Unfortunately I don't have a fix for this, but I have seen similar
behavior.  I have only been able to get the SplitStream block on the first
run after an FPGA reconfiguration (or X310 power cycle).  If you try
running the flowgraph a second time, it hangs and nothing gets through the
SplitStream.

On Wed, Jun 6, 2018 at 7:05 PM, Peter Sanchez via USRP-users <
usrp-users@lists.ettus.com> wrote:

> Hi All,
>
> I have a RFNoC Receiver --> Split stream --> x2 DDC blocks on the X310.
> I see a ton of overrun on chan 0 errors after adding the Split Stream
> block and GNU Radio Companion eventually crashes all together.
>
>
> I read about a similar problem on the E310 and the fix was to change the
> ce_clk to bus_clk in the rfnoc_ce_auto_inst (http://lists.ettus.com/piperm
> ail/usrp-users_lists.ettus.com/2017-February/023539.html).
> I tried changing that in the rfnoc_ce_auto_inst_x310.v code and reflashed
> the FPGA but this didn't change the overrun errors.
>
> Any thoughts?
> Thanks!
>
> _______________________________________________
> USRP-users mailing list
> USRP-users@lists.ettus.com
> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
>
>
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com

Reply via email to