On 12/28/2017 11:52 AM, ALEJANDRO BLANCO PIZARRO wrote:
Yeah, sure, The output is:
sudo uhd_usrp_probe --args "type=x310"
linux; GNU C++ version 5.4.0 20160609; Boost_105800;
UHD_003.010.002.000-release
Error: LookupError: KeyError: No devices found for ----->
Device Address:
type: x310
I must apologize, I should have said "type=x300".
But your subsequent uhd_usrp_probe output (note, that sudo should not be
required for any of this) shows that the version of UHD you have recognizes
the card
My guess is that your srsLTE environment is linked against a different,
older, version of UHD which doesn't have TwinRX support. Note also that
a full
LTE stack will not work with a receive-only card like the TwinRX.
I am not pretty sure that the command is correct. So, I am going to
show you the output of sudo uhd_usrp_probe too:
linux; GNU C++ version 5.4.0 20160609; Boost_105800;
UHD_003.010.002.000-release
-- X300 initialization sequence...
-- Determining maximum frame size... 8000 bytes.
-- Setup basic communication...
-- Loading values from EEPROM...
-- Setup RF frontend clocking...
-- Radio 1x clock:200
-- Detecting internal GPSDO.... Found an internal GPSDO: LC_XO,
Firmware Rev 0.929a
-- [DMA FIFO] Running BIST for FIFO 0... pass (Throughput: 1304.7MB/s)
-- [DMA FIFO] Running BIST for FIFO 1... pass (Throughput: 1304.5MB/s)
-- [RFNoC Radio] Performing register loopback test... pass
-- [RFNoC Radio] Performing register loopback test... pass
-- [RFNoC Radio] Performing register loopback test... pass
-- [RFNoC Radio] Performing register loopback test... pass
-- Performing timer loopback test... pass
-- Performing timer loopback test... pass
_____________________________________________________
/
| Device: X-Series Device
| _____________________________________________________
| /
| | Mboard: X310
| | revision: 7
| | revision_compat: 7
| | product: 30818
| | mac-addr0: 00:80:2f:21:e4:65
| | mac-addr1: 00:80:2f:21:e4:66
| | gateway: 192.168.10.1
| | ip-addr0: 192.168.10.2
| | subnet0: 255.255.255.0
| | ip-addr1: 192.168.20.2
| | subnet1: 255.255.255.0
| | ip-addr2: 192.168.30.2
| | subnet2: 255.255.255.0
| | ip-addr3: 192.168.50.2
| | subnet3: 255.255.255.0
| | serial: 30AAD25
| | FW Version: 5.1
| | FPGA Version: 33.0
| | RFNoC capable: Yes
| |
| | Time sources: internal, external, gpsdo
| | Clock sources: internal, external, gpsdo
| | Sensors: gps_gpgga, gps_gprmc, gps_time, gps_locked,
gps_servo, ref_locked
| | _____________________________________________________
| | /
| | | RX Dboard: A
| | | ID: TwinRX v1.1 (0x0093)
| | | Serial: 3129E7C
| | | _____________________________________________________
| | | /
| | | | RX Frontend: 0
| | | | Name: TwinRX RX0
| | | | Antennas: RX1, RX2
| | | | Sensors: lo_locked
| | | | Freq range: 10.000 to 6000.000 MHz
| | | | Gain range all: 0.0 to 95.0 step 1.0 dB
| | | | Bandwidth range: 80000000.0 to 80000000.0 step 0.0 Hz
| | | | Connection Type: II
| | | | Uses LO offset: No
| | | _____________________________________________________
| | | /
| | | | RX Frontend: 1
| | | | Name: TwinRX RX1
| | | | Antennas: RX1, RX2
| | | | Sensors: lo_locked
| | | | Freq range: 10.000 to 6000.000 MHz
| | | | Gain range all: 0.0 to 95.0 step 1.0 dB
| | | | Bandwidth range: 80000000.0 to 80000000.0 step 0.0 Hz
| | | | Connection Type: QQ
| | | | Uses LO offset: No
| | | _____________________________________________________
| | | /
| | | | RX Codec: A
| | | | Name: ads62p48
| | | | Gain range digital: 0.0 to 6.0 step 0.5 dB
| | _____________________________________________________
| | /
| | | RX Dboard: B
| | | ID: TwinRX v1.1 (0x0093)
| | | Serial: 31293DD
| | | _____________________________________________________
| | | /
| | | | RX Frontend: 0
| | | | Name: TwinRX RX0
| | | | Antennas: RX1, RX2
| | | | Sensors: lo_locked
| | | | Freq range: 10.000 to 6000.000 MHz
| | | | Gain range all: 0.0 to 95.0 step 1.0 dB
| | | | Bandwidth range: 80000000.0 to 80000000.0 step 0.0 Hz
| | | | Connection Type: II
| | | | Uses LO offset: No
| | | _____________________________________________________
| | | /
| | | | RX Frontend: 1
| | | | Name: TwinRX RX1
| | | | Antennas: RX1, RX2
| | | | Sensors: lo_locked
| | | | Freq range: 10.000 to 6000.000 MHz
| | | | Gain range all: 0.0 to 95.0 step 1.0 dB
| | | | Bandwidth range: 80000000.0 to 80000000.0 step 0.0 Hz
| | | | Connection Type: QQ
| | | | Uses LO offset: No
| | | _____________________________________________________
| | | /
| | | | RX Codec: B
| | | | Name: ads62p48
| | | | Gain range digital: 0.0 to 6.0 step 0.5 dB
| | _____________________________________________________
| | /
| | | TX Dboard: A
| | | ID: Unknown (0x0092)
| | | Serial: 312928F
| | | _____________________________________________________
| | | /
| | | | TX Frontend: 0
| | | | Name: Unknown (0x0092) - 0
| | | | Antennas:
| | | | Sensors:
| | | | Freq range: 0.000 to 0.000 MHz
| | | | Gain Elements: None
| | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz
| | | | Connection Type: IQ
| | | | Uses LO offset: No
| | | _____________________________________________________
| | | /
| | | | TX Codec: A
| | | | Name: ad9146
| | | | Gain Elements: None
| | _____________________________________________________
| | /
| | | TX Dboard: B
| | | ID: Unknown (0x0092)
| | | Serial: 3129283
| | | _____________________________________________________
| | | /
| | | | TX Frontend: 0
| | | | Name: Unknown (0x0092) - 0
| | | | Antennas:
| | | | Sensors:
| | | | Freq range: 0.000 to 0.000 MHz
| | | | Gain Elements: None
| | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz
| | | | Connection Type: IQ
| | | | Uses LO offset: No
| | | _____________________________________________________
| | | /
| | | | TX Codec: B
| | | | Name: ad9146
| | | | Gain Elements: None
| | _____________________________________________________
| | /
| | | RFNoC blocks on this device:
| | |
| | | * DmaFIFO_0
| | | * Radio_0
| | | * Radio_1
| | | * DDC_0
| | | * DDC_1
| | | * DUC_0
| | | * DUC_1
Best,
Alejandro
2017-12-28 17:19 GMT+01:00 Marcus D. Leech via USRP-users
<usrp-users@lists.ettus.com <mailto:usrp-users@lists.ettus.com>>:
On 12/28/2017 10:10 AM, ALEJANDRO BLANCO PIZARRO via USRP-users wrote:
Dear Marcus,
Thanks for the response. The UHD version is
UHD_003.010.002.000-release.
So, this version is the correct one?
Best regards,
Alejandro
Could you show us the output of:
uhd_usrp_probe --args "type=x310"
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com <mailto:USRP-users@lists.ettus.com>
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
<http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com>
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
