Hi Alejandro, The TwinRX does not support a 184.32e6 Master Clock Rate which is required for srsLTE. The TwinRX DBs also will not work with srsLTE as they do not have any TX channels.
Regards, Nate Temple > On Dec 28, 2017, at 8:52 AM, ALEJANDRO BLANCO PIZARRO via USRP-users > <usrp-users@lists.ettus.com> wrote: > > Yeah, sure, The output is: > > sudo uhd_usrp_probe --args "type=x310" > linux; GNU C++ version 5.4.0 20160609; Boost_105800; > UHD_003.010.002.000-release > > Error: LookupError: KeyError: No devices found for -----> > Device Address: > type: x310 > > > I am not pretty sure that the command is correct. So, I am going to show you > the output of sudo uhd_usrp_probe too: > > linux; GNU C++ version 5.4.0 20160609; Boost_105800; > UHD_003.010.002.000-release > > -- X300 initialization sequence... > -- Determining maximum frame size... 8000 bytes. > -- Setup basic communication... > -- Loading values from EEPROM... > -- Setup RF frontend clocking... > -- Radio 1x clock:200 > -- Detecting internal GPSDO.... Found an internal GPSDO: LC_XO, Firmware Rev > 0.929a > -- [DMA FIFO] Running BIST for FIFO 0... pass (Throughput: 1304.7MB/s) > -- [DMA FIFO] Running BIST for FIFO 1... pass (Throughput: 1304.5MB/s) > -- [RFNoC Radio] Performing register loopback test... pass > -- [RFNoC Radio] Performing register loopback test... pass > -- [RFNoC Radio] Performing register loopback test... pass > -- [RFNoC Radio] Performing register loopback test... pass > -- Performing timer loopback test... pass > -- Performing timer loopback test... pass > _____________________________________________________ > / > | Device: X-Series Device > | _____________________________________________________ > | / > | | Mboard: X310 > | | revision: 7 > | | revision_compat: 7 > | | product: 30818 > | | mac-addr0: 00:80:2f:21:e4:65 > | | mac-addr1: 00:80:2f:21:e4:66 > | | gateway: 192.168.10.1 > | | ip-addr0: 192.168.10.2 > | | subnet0: 255.255.255.0 > | | ip-addr1: 192.168.20.2 > | | subnet1: 255.255.255.0 > | | ip-addr2: 192.168.30.2 > | | subnet2: 255.255.255.0 > | | ip-addr3: 192.168.50.2 > | | subnet3: 255.255.255.0 > | | serial: 30AAD25 > | | FW Version: 5.1 > | | FPGA Version: 33.0 > | | RFNoC capable: Yes > | | > | | Time sources: internal, external, gpsdo > | | Clock sources: internal, external, gpsdo > | | Sensors: gps_gpgga, gps_gprmc, gps_time, gps_locked, gps_servo, > ref_locked > | | _____________________________________________________ > | | / > | | | RX Dboard: A > | | | ID: TwinRX v1.1 (0x0093) > | | | Serial: 3129E7C > | | | _____________________________________________________ > | | | / > | | | | RX Frontend: 0 > | | | | Name: TwinRX RX0 > | | | | Antennas: RX1, RX2 > | | | | Sensors: lo_locked > | | | | Freq range: 10.000 to 6000.000 MHz > | | | | Gain range all: 0.0 to 95.0 step 1.0 dB > | | | | Bandwidth range: 80000000.0 to 80000000.0 step 0.0 Hz > | | | | Connection Type: II > | | | | Uses LO offset: No > | | | _____________________________________________________ > | | | / > | | | | RX Frontend: 1 > | | | | Name: TwinRX RX1 > | | | | Antennas: RX1, RX2 > | | | | Sensors: lo_locked > | | | | Freq range: 10.000 to 6000.000 MHz > | | | | Gain range all: 0.0 to 95.0 step 1.0 dB > | | | | Bandwidth range: 80000000.0 to 80000000.0 step 0.0 Hz > | | | | Connection Type: QQ > | | | | Uses LO offset: No > | | | _____________________________________________________ > | | | / > | | | | RX Codec: A > | | | | Name: ads62p48 > | | | | Gain range digital: 0.0 to 6.0 step 0.5 dB > | | _____________________________________________________ > | | / > | | | RX Dboard: B > | | | ID: TwinRX v1.1 (0x0093) > | | | Serial: 31293DD > | | | _____________________________________________________ > | | | / > | | | | RX Frontend: 0 > | | | | Name: TwinRX RX0 > | | | | Antennas: RX1, RX2 > | | | | Sensors: lo_locked > | | | | Freq range: 10.000 to 6000.000 MHz > | | | | Gain range all: 0.0 to 95.0 step 1.0 dB > | | | | Bandwidth range: 80000000.0 to 80000000.0 step 0.0 Hz > | | | | Connection Type: II > | | | | Uses LO offset: No > | | | _____________________________________________________ > | | | / > | | | | RX Frontend: 1 > | | | | Name: TwinRX RX1 > | | | | Antennas: RX1, RX2 > | | | | Sensors: lo_locked > | | | | Freq range: 10.000 to 6000.000 MHz > | | | | Gain range all: 0.0 to 95.0 step 1.0 dB > | | | | Bandwidth range: 80000000.0 to 80000000.0 step 0.0 Hz > | | | | Connection Type: QQ > | | | | Uses LO offset: No > | | | _____________________________________________________ > | | | / > | | | | RX Codec: B > | | | | Name: ads62p48 > | | | | Gain range digital: 0.0 to 6.0 step 0.5 dB > | | _____________________________________________________ > | | / > | | | TX Dboard: A > | | | ID: Unknown (0x0092) > | | | Serial: 312928F > | | | _____________________________________________________ > | | | / > | | | | TX Frontend: 0 > | | | | Name: Unknown (0x0092) - 0 > | | | | Antennas: > | | | | Sensors: > | | | | Freq range: 0.000 to 0.000 MHz > | | | | Gain Elements: None > | | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz > | | | | Connection Type: IQ > | | | | Uses LO offset: No > | | | _____________________________________________________ > | | | / > | | | | TX Codec: A > | | | | Name: ad9146 > | | | | Gain Elements: None > | | _____________________________________________________ > | | / > | | | TX Dboard: B > | | | ID: Unknown (0x0092) > | | | Serial: 3129283 > | | | _____________________________________________________ > | | | / > | | | | TX Frontend: 0 > | | | | Name: Unknown (0x0092) - 0 > | | | | Antennas: > | | | | Sensors: > | | | | Freq range: 0.000 to 0.000 MHz > | | | | Gain Elements: None > | | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz > | | | | Connection Type: IQ > | | | | Uses LO offset: No > | | | _____________________________________________________ > | | | / > | | | | TX Codec: B > | | | | Name: ad9146 > | | | | Gain Elements: None > | | _____________________________________________________ > | | / > | | | RFNoC blocks on this device: > | | | > | | | * DmaFIFO_0 > | | | * Radio_0 > | | | * Radio_1 > | | | * DDC_0 > | | | * DDC_1 > | | | * DUC_0 > | | | * DUC_1 > > > Best, > Alejandro > > 2017-12-28 17:19 GMT+01:00 Marcus D. Leech via USRP-users > <usrp-users@lists.ettus.com>: > On 12/28/2017 10:10 AM, ALEJANDRO BLANCO PIZARRO via USRP-users wrote: > Dear Marcus, > > Thanks for the response. The UHD version is UHD_003.010.002.000-release. > > So, this version is the correct one? > > Best regards, > Alejandro > > Could you show us the output of: > > uhd_usrp_probe --args "type=x310" > > > > > _______________________________________________ > USRP-users mailing list > USRP-users@lists.ettus.com > http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com > > _______________________________________________ > USRP-users mailing list > USRP-users@lists.ettus.com > http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com _______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
