On 10/31/2017 04:21 PM, Mark Koenig via USRP-users wrote:
Again,
Looking to see if anyone can help on this.
One more detail is that I am unable to reboot the N210 into safe mode,
thus no green lights come on.
Thanks
Mark
OK, so you've followed the JTAG-based procedures here
https://kb.ettus.com/N200/N210_Device_Recovery
ANd still cannot get it to "go" ?
*From: *Mark Koenig <mark.koe...@iubelttechnologies.com>
*Date: *Thursday, October 26, 2017 at 1:25 PM
*To: *"usrp-users@lists.ettus.com" <usrp-users@lists.ettus.com>
*Subject: *Re: Reprogramming a "Bricked" N210
Just bringing this back to the top.
*From: *Mark Koenig <mark.koe...@iubelttechnologies.com>
*Date: *Monday, October 23, 2017 at 2:26 PM
*To: *"usrp-users@lists.ettus.com" <usrp-users@lists.ettus.com>
*Subject: *Reprogramming a "Bricked" N210
I have been trying to use Vivado lab to return my N210 to a useable
state and am looking for some help.
I see the green light lit on the Xilinx USB to JTAG adaptor and the
connection seems good, however, I keep getting errors during the
programming of the EE_PROM. Below is what I constantly see when
trying to reprogram the N210.
Any help would be greatly appreciated.
Thank you
Mark
set_property PROBES.FILE {} [lindex [get_hw_devices] 0]
set_property PROGRAM.FILE {/usr/local/share/uhd/images/usrp2_fpga.bin}
[lindex [get_hw_devices] 0]
program_hw_devices [lindex [get_hw_devices] 0]
ERROR: [Labtools 27-3165] End of startup status: LOW
ERROR: [Common 17-39] 'program_hw_devices' failed due to earlier errors.
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
_______________________________________________
USRP-users mailing list
USRP-users@lists.ettus.com
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
