Mark, where are you saving the standalone to? Any chance that the target folder is on iCloud drive. E.g. Desktop or Documents folder?
I had similar problems in the past when i built the standalone directly on the Desktop or Documents folder which were both synchronized with iCloud Drive. I just cannot remember the correct error message. Sometimes the build process was successful and sometimes it was aborted. I could solve this to select a target folder outside of iCloud Drive. Btw. building the standalone in a Dropbox folder works w/o problems. Matthias > Am 01.02.2022 um 11:47 schrieb Mark Smith via use-livecode > <use-livecode@lists.runrev.com>: > > Hi Panos, > > I did not change anything between attempts, just one right after the other. I > guess I was observing this in RC2 and just persisted and it seemed to work on > the 2nd or 3rd attempt. For good measure I just took the same stack and was > able to build and install two more times without incident so it’s definitely > not a repeatable problem and as yet I have no formula or hypothesis as to > what might be causing it. I’ll keep an eye on it and log any similar problems > I run across. > > Mark > > >> On Feb 1, 2022, at 10:23 AM, panagiotis m via use-livecode >> <use-livecode@lists.runrev.com> wrote: >> >> Hello Mark, >> >> I have not seen this before. Did anything change in your stack (used a >> different provisioning profile or changed anything in the iOS settings) or >> in the iOS device until the successful 3rd attempt? >> >> I cannot remember of anything that we changed in the 9.6.6 release cycle >> that could have caused this behavior. >> >> Kind regards, >> Panos >> >> On Tue, 1 Feb 2022 at 12:14, Mark Smith via use-livecode < >> use-livecode@lists.runrev.com> wrote: >> >>> I just wanted to flag this issue. I am currently using the new release >>> version of 9.6.6 although I did have similar problems with RC2 as well. >>> This morning I took a stack I had previously built and successfully >>> installed (using Development/Test Target -> iPhone) and tried installing >>> it. The first time the app went through what appeared to be all the build >>> steps but did not install the app. The 2nd time it went through all of the >>> steps and then reported “Unknown Error” and the 3rd time it built and >>> installed the app correctly. I’ve not noticed behaviour like this in >>> previous versions. At the moment I have no hypothesis about what might be >>> going on. >>> >>> Mark >>> >>> >>> _______________________________________________ >>> use-livecode mailing list >>> use-livecode@lists.runrev.com >>> Please visit this url to subscribe, unsubscribe and manage your >>> subscription preferences: >>> http://lists.runrev.com/mailman/listinfo/use-livecode >>> >> _______________________________________________ >> use-livecode mailing list >> use-livecode@lists.runrev.com >> Please visit this url to subscribe, unsubscribe and manage your subscription >> preferences: >> http://lists.runrev.com/mailman/listinfo/use-livecode > > > _______________________________________________ > use-livecode mailing list > use-livecode@lists.runrev.com > Please visit this url to subscribe, unsubscribe and manage your subscription > preferences: > http://lists.runrev.com/mailman/listinfo/use-livecode _______________________________________________ use-livecode mailing list use-livecode@lists.runrev.com Please visit this url to subscribe, unsubscribe and manage your subscription preferences: http://lists.runrev.com/mailman/listinfo/use-livecode
