On 10/7/2012 11:19 AM, Eric Nelson wrote:
Hi Troy,
On 10/03/2012 06:47 PM, Troy Kisky wrote:
The '#' used as comments in the files cause the preprocessor
trouble, so change to /* */.
Signed-off-by: Troy Kisky<troy.ki...@boundarydevices.com>
---
Makefile | 3 +-
board/esg/ima3-mx53/imximage.cfg | 120 ++++++-----
board/freescale/imx/ddr/mx6q_4x_mt41j128.cfg | 90 ++++----
board/freescale/mx25pdk/imximage.cfg | 77 +++----
board/freescale/mx51evk/imximage.cfg | 114 +++++-----
board/freescale/mx53ard/imximage_dd3.cfg | 83 ++++----
board/freescale/mx53evk/imximage.cfg | 86 ++++----
board/freescale/mx53loco/imximage.cfg | 83 ++++----
board/freescale/mx53smd/imximage.cfg | 83 ++++----
board/freescale/mx6qarm2/imximage.cfg | 88 ++++----
board/genesi/mx51_efikamx/imximage_mx.cfg | 132 ++++++------
board/genesi/mx51_efikamx/imximage_sb.cfg | 126 +++++------
board/ttcontrol/vision2/imximage_hynix.cfg | 295
++++++++++++++------------
13 files changed, 727 insertions(+), 653 deletions(-)
diff --git a/Makefile b/Makefile
index a40d4cc..64ff1b8 100644
--- a/Makefile
+++ b/Makefile
@@ -431,7 +431,8 @@ $(obj)u-boot.img: $(obj)u-boot.bin
-d $< $@
$(obj)u-boot.imx: $(obj)u-boot.bin
- $(obj)tools/mkimage -n $(CONFIG_IMX_CONFIG) -T imximage \
+ $(CC) -E -x c $(CONFIG_IMX_CONFIG) -I./include -o
$(obj)imxcfg.imx
+ $(obj)tools/mkimage -n $(obj)imxcfg.imx -T imximage \
-e $(CONFIG_SYS_TEXT_BASE) -d $< $@
This bit creates imxcfg.imx.
If built in-tree, the file will be reported as a new file in 'git
status'.
Is there a reason it can't be deleted after the build?
Just being able to look at it to see that the output makes sense.
I should make sure that make clean, deletes it, but I kinda like being
able to look at it after a make all.
Is an entry in gitignore ok?
Is everyone OK was the file name imxcfg.imx, or should some other
extension be used?
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
