Hi Benoît ,
On Mon, Sep 17, 2012 at 4:04 PM, Benoît Thébaudeau
<benoit.thebaud...@advansee.com> wrote:
> +u32 get_board_rev(void)
> +{
> + return get_cpu_rev();
> +}
Is this enough? Looking at FSL U-boot there is also a:
static inline void set_board_rev(void)
{
if ((__REG(GPIO1_BASE_ADDR + 0x0) & (0x1 << 22)) == 0)
system_rev |= BOARD_REV_2_0 << BOARD_VER_OFFSET;
}
On mx53loco I had very weird problems when kernel was running and it
took me sometime to find out that it was due to wrong detection of the
board revision, so I suggest to double check this to avoid this kind
of problem on mx51evk too.
Regards,
Fabio Estevam
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
