> -----Original Message----- > From: Wolfgang Denk [mailto:w...@denx.de] > Sent: 03 July 2012 23:31 > To: Prafulla Wadaskar > Cc: Holger Brunck; u-boot@lists.denx.de; Valentin Longchamp > Subject: Re: [U-Boot] [PATCH v2 03/14] arm/km: convert mgcoge3un > target to km_kirkwood > > Dear Prafulla, > > In message <F766E4F80769BD478052FB6533FA745D1A2FE3028D@SC- > VEXCH4.marvell.com> you wrote: > > > > Do you think I should pull this patch series, I hope it applies > cleanly on the recent master branch. > > Please confirm. > > I have to admit that I neither reviewed the patches in question, nor > did I follow the whole thread of communication in this patch series. > But the general rule is that if there are no strong argumentents > against a patch (like a clear NAK or a specific request for changes) > we will apply it.
Hi Wolfgang, This patch series was too old, I was trying to save my effors ;-D Finally I pulled these patches and tried to apply, but as I doubted it failed :-( Hi Hogler I could not apply the said patch series to the latest u-boot-marvell.git master branch Pls re-submit it. git-am U-Boot-1-9-arm-km-add-board-type-to-boards.cfg.patch Applying arm/km: add board type to boards.cfg error: patch failed: boards.cfg:138 error: boards.cfg: patch does not apply error: patch failed: include/configs/km_kirkwood.h:42 error: include/configs/km_kirkwood.h: patch does not apply Patch failed at 0001. When you have resolved this problem run "git-am --resolved". If you would prefer to skip this patch, instead run "git-am --skip" Regards.. Prafulla . . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
