On 07/05/2012 22:26, Fabio Estevam wrote: > From: Fabio Estevam <fabio.este...@freescale.com> > > On the mx53loco board with mc34708 PMIC it is necessary to turn on VUSB > regulator > so that the mx53 USBH1 PHY receives the 3.3V voltage. > > Tested by inserting a USB pen drive in the upper USB slot (USBH1) and then > issued the > commands: > > usb start > > usb info > > ,which correctly detected and printed the USB pen drive information. > > Signed-off-by: Fabio Estevam <fabio.este...@freescale.com> > ---
Applied to u-boot-imx, thanks Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-53 Fax: +49-8142-66989-80 Email: sba...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
