Tero,
[snip]
>> > - {UART2_CTS, (PTU | IEN | M0)}, /*
>> > uart2_cts */
>> > - {UART2_RTS, (M0)}, /*
>> > uart2_rts */
>> > - {UART2_RX, (PTU | IEN | M0)}, /*
>> > uart2_rx */
>> > - {UART2_TX, (M0)}, /*
>> > uart2_tx */
>> > + {UART2_CTS, (PTU | IEN | M7)}, /*
>> > uart2_cts */
>> > + {UART2_RTS, (M7)}, /*
>> > uart2_rts */
>> > + {UART2_RX, (PTU | IEN | M7)}, /*
>> > uart2_rx */
>> > + {UART2_TX, (M7)}, /*
>> > uart2_tx */
>> > {HDQ_SIO, (M3)}, /*
>> > gpio_127 */
>> > {MCSPI1_CLK, (IEN | OFF_EN | OFF_PD | OFF_IN | M0)}, /*
>> > mcspi1_clk */
>> > {MCSPI1_SOMI, (IEN | OFF_EN | OFF_PD | OFF_IN | M0)}, /*
>> > mcspi1_somi */
>> > --
>>
>> How about not muxing and keeping the pads at reset modes ( safe mode).
>> If this works , then better to remove these pads from the table.
>
> This works also, just tried it out to double check.
Thanks. Then better to just remove these entries.
Thanks,
Sricharan
_______________________________________________
U-Boot mailing list
[email protected]
http://lists.denx.de/mailman/listinfo/u-boot
