On Sat, 2012-05-05 at 15:04 +0530, R, Sricharan wrote:
> Hi Tero,
>
> On Wed, Apr 25, 2012 at 9:35 PM, Tero Kristo <t-kri...@ti.com> wrote:
> > If uart2 is enabled during boot, spurious wifi chip transmission will
> > hang the module and it is impossible to recover from this situation
> > without hard reset. This will prevent any l4_per domain idle
> > transitions.
> >
> > Signed-off-by: Tero Kristo <t-kri...@ti.com>
> > ---
> > board/ti/panda/panda_mux_data.h | 8 ++++----
> > 1 files changed, 4 insertions(+), 4 deletions(-)
> >
> > diff --git a/board/ti/panda/panda_mux_data.h
> > b/board/ti/panda/panda_mux_data.h
> > index 3efc22a..dc8b388 100644
> > --- a/board/ti/panda/panda_mux_data.h
> > +++ b/board/ti/panda/panda_mux_data.h
> > @@ -168,10 +168,10 @@ const struct pad_conf_entry
> > core_padconf_array_non_essential[] = {
> > {ABE_DMIC_DIN1, (IEN | M0)}, /*
> > abe_dmic_din1 */
> > {ABE_DMIC_DIN2, (PTU | IEN | M3)}, /*
> > gpio_121 */
> > {ABE_DMIC_DIN3, (IEN | M0)}, /*
> > abe_dmic_din3 */
> > - {UART2_CTS, (PTU | IEN | M0)}, /*
> > uart2_cts */
> > - {UART2_RTS, (M0)}, /*
> > uart2_rts */
> > - {UART2_RX, (PTU | IEN | M0)}, /*
> > uart2_rx */
> > - {UART2_TX, (M0)}, /*
> > uart2_tx */
> > + {UART2_CTS, (PTU | IEN | M7)}, /*
> > uart2_cts */
> > + {UART2_RTS, (M7)}, /*
> > uart2_rts */
> > + {UART2_RX, (PTU | IEN | M7)}, /*
> > uart2_rx */
> > + {UART2_TX, (M7)}, /*
> > uart2_tx */
> > {HDQ_SIO, (M3)}, /*
> > gpio_127 */
> > {MCSPI1_CLK, (IEN | OFF_EN | OFF_PD | OFF_IN | M0)}, /*
> > mcspi1_clk */
> > {MCSPI1_SOMI, (IEN | OFF_EN | OFF_PD | OFF_IN | M0)}, /*
> > mcspi1_somi */
> > --
>
> How about not muxing and keeping the pads at reset modes ( safe mode).
> If this works , then better to remove these pads from the table.
This works also, just tried it out to double check.
-Tero
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
