There is a 'gpio_direction_output(87, 0);' call previously, so the GPIO
direction is
already established.
Use gpio_set_value() for changing the GPIO output then.
Signed-off-by: Fabio Estevam <fabio.este...@freescale.com>
---
board/freescale/mx6qsabrelite/mx6qsabrelite.c | 2 +-
1 files changed, 1 insertions(+), 1 deletions(-)
diff --git a/board/freescale/mx6qsabrelite/mx6qsabrelite.c
b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
index 1d09a72..2155d87 100644
--- a/board/freescale/mx6qsabrelite/mx6qsabrelite.c
+++ b/board/freescale/mx6qsabrelite/mx6qsabrelite.c
@@ -135,7 +135,7 @@ static void setup_iomux_enet(void)
/* Need delay 10ms according to KSZ9021 spec */
udelay(1000 * 10);
- gpio_direction_output(87, 1); /* GPIO 3-23 */
+ gpio_set_value(87, 1); /* GPIO 3-23 */
imx_iomux_v3_setup_multiple_pads(enet_pads2, ARRAY_SIZE(enet_pads2));
}
--
1.7.1
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
