Hi Tom, On 13.12.2011 23:30, Tom Rini wrote: >>>> +#define CONFIG_SYS_TEXT_BASE 0x80008000 >>> [snip] >>>> +#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 0x300 /* address >>>> 0x60000 */ >>>> +#define CONFIG_SYS_MMC_SD_FAT_BOOT_PARTITION 1 >>>> +#define CONFIG_SPL_FAT_LOAD_PAYLOAD_NAME "u-boot.img" >>> >>> You're able to have CONFIG_SYS_TEXT_BASE that low and not have the >>> corruption problem devkit8000 had? >> >> No, I can't see any problems. I have to say I can't do _real_ MMC boot, >> as my board lacks the required jumper, so I'm testing it but starting >> SPL from NAND, rewriting omap3_boot_device to be MMC with BDI and >> running it further. It reads u-boot.img from MMC and starts it without >> any problem. > > Well, is it just your board that's missing the jumper, or the MCX HTWK > lacks the jumper? If the latter, just drop the MMC bits out :)
I can't ;) this was an explicit requirement. As for the devkit8000 boot problem, I have BSS set up close to the top of the RAM. Probably that's the reason I don't see any problems. Unfortunately, I can't recall why I had moved BSS... It clashed with something but I don't remember the details. Regards, Ilya. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
