On Mon, Dec 12, 2011 at 4:15 PM, Ilya Yanok <ya...@emcraft.com> wrote:
> This patch adds support for the HTKW mcx AM3517-based board.
> Serial, Ethernet, NAND, MMC, RTC, EHCI USB host and both
> NAND and MMC SPLs are supported.
>
> Requires updated mach-types file.
Just define the MACH_ID locally for now so it builds still please.
Also, some problems:
> +#if defined(CONFIG_OMAP_HSMMC) && !defined(CONFIG_SPL_BUILD)
> +int board_mmc_init(bd_t *bis)
> +{
> + omap_mmc_init(0);
> + return 0;
> +}
> +#endif
That should just be return omap_mmc_init(0);
[snip to config file]
> +#define CONFIG_SYS_TEXT_BASE 0x80008000
[snip]
> +#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 0x300 /* address
> 0x60000 */
> +#define CONFIG_SYS_MMC_SD_FAT_BOOT_PARTITION 1
> +#define CONFIG_SPL_FAT_LOAD_PAYLOAD_NAME "u-boot.img"
You're able to have CONFIG_SYS_TEXT_BASE that low and not have the
corruption problem devkit8000 had?
> +#define CONFIG_SYS_NAND_U_BOOT_SIZE 0x60000
IIRC you don't need this define since this SPL says you write
u-boot.img to NAND not u-boot.bin
--
Tom
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
