On Tue, Dec 13, 2011 at 12:13 PM, Ilya Yanok <ya...@emcraft.com> wrote: > Hi Tom, > > On 13.12.2011 22:52, Tom Rini wrote: >>> +#define CONFIG_SYS_TEXT_BASE 0x80008000 >> [snip] >>> +#define CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR 0x300 /* address >>> 0x60000 */ >>> +#define CONFIG_SYS_MMC_SD_FAT_BOOT_PARTITION 1 >>> +#define CONFIG_SPL_FAT_LOAD_PAYLOAD_NAME "u-boot.img" >> >> You're able to have CONFIG_SYS_TEXT_BASE that low and not have the >> corruption problem devkit8000 had? > > No, I can't see any problems. I have to say I can't do _real_ MMC boot, > as my board lacks the required jumper, so I'm testing it but starting > SPL from NAND, rewriting omap3_boot_device to be MMC with BDI and > running it further. It reads u-boot.img from MMC and starts it without > any problem.
Well, is it just your board that's missing the jumper, or the MCX HTWK lacks the jumper? If the latter, just drop the MMC bits out :) -- Tom _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
