On 10/28/2011 11:21 AM, Fabio Porcedda wrote: > Hi all, > i'm trying to use the u-boot on an at91sam9260ek board, > i cannot start successfull the u-boot binary. >
Hi Fabio, > Hit any key to stop autoboot: 0 > U-Boot> loadb > ## Ready for binary (kermit) download to 0x22000000 at 115200 bps... > Well, it is not clear to me why you want to run u-boot as single application, instead of replacing the version you have now on target. And why are you loading u-boot at 0x22000000, because if I see in the include/configs/at91sam9260ek.h CONFIG_SYS_TEXT_BASE is set to 0x21f00000... Apart of that, you should also check the bootstrap code (not part of u-boot), and maybe you have to fix it if the addresses do not correspond or a smaller image from NAND flash as u-boot is copied. Best regards, Stefano Babic -- ===================================================================== DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: +49-8142-66989-0 Fax: +49-8142-66989-80 Email: off...@denx.de ===================================================================== _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot