Dear Christopher Harvey,
In message <20110706205857.gb2...@harvey-pc.matrox.com> you wrote:
>
> > Also delete "for ARM", and s/arm/<arch>/. This is not ARM specific.
>
> I don't understand, I found the following snippet in
> arch/arm/lib/board.c
>
> --addr defined and set here--
>
> gd->relocaddr = addr;
> gd->start_addr_sp = addr_sp;
> gd->reloc_off = addr - _TEXT_BASE;
> debug ("relocation Offset is: %08lx\n", gd->reloc_off);
> memcpy (id, (void *)gd, sizeof (gd_t));
>
> relocate_code (addr_sp, id, addr);
> /* NOTREACHED - relocate_code() does not return */
>
> Running grep -R gd->relocaddr *,
> I found similar assignments for various architectures.
Yes, that's what I said: this is not ARM specific, it is supposed to
be common code used by all architectures (except for the sad fact that
there are several non-conforming implementations). But if we document
it, we should document the nominal state. [If in doubt, use the
powerpc implementation as reference.]
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
"It is better to have tried and failed than to have failed to try,
but the result's the same." - Mike Dennison
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
