Dear Fabio Estevam,
In message <1308069108-5438-1-git-send-email-fabio.este...@freescale.com> you
wrote:
...
> However it is possible to find some pre-production silicon on some old
> hardware, such as MX31ADS
> that shows srev = 0x20.
>
> The following message is the currently displayed on such MX31ADS board:
>
> CPU: Freescale i.MX31 rev 2.0 unknown at 531 MHz.Reset cause: WDOG
>
> With this patch we see a better message like:
>
> CPU: Freescale i.MX31 rev 0.0 (unknown revision) at 531 MHz.Reset cause:
> WDOG
The old information is way more useful, and shorter, than the new one.
And the code is smaller and without any magic, too.
I agree with Graeme: we should rather leave the code as is.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
"Unix is simple, but it takes a genius to understand the simplicity."
- Dennis Ritchie
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
