The USB0 instance of USB on J722S SoC is a Designware USB Controller with the same glue layer (wrapper) as AM62 SoC. In order to support USB DFU boot and USB DFU flash with USB0, enable the corresponding glue layer driver.
While at it, sync with savedefconfig. Signed-off-by: Siddharth Vadapalli <s-vadapa...@ti.com> --- This patch has been newly introduced in this series. Regards, Siddharth. configs/j722s_evm_a53_defconfig | 5 +++-- 1 file changed, 3 insertions(+), 2 deletions(-) diff --git a/configs/j722s_evm_a53_defconfig b/configs/j722s_evm_a53_defconfig index 81eb934ed6..b53dc3054f 100644 --- a/configs/j722s_evm_a53_defconfig +++ b/configs/j722s_evm_a53_defconfig @@ -1,6 +1,7 @@ CONFIG_ARM=y CONFIG_ARCH_K3=y CONFIG_SYS_MALLOC_F_LEN=0x8000 +CONFIG_TI_COMMON_CMD_OPTIONS=y CONFIG_SPL_GPIO=y CONFIG_SPL_LIBCOMMON_SUPPORT=y CONFIG_SPL_LIBGENERIC_SUPPORT=y @@ -54,7 +55,6 @@ CONFIG_SYS_SPI_U_BOOT_OFFS=0x280000 CONFIG_SPL_THERMAL=y CONFIG_SPL_YMODEM_SUPPORT=y CONFIG_CMD_CLK=y -CONFIG_CMD_DFU=y CONFIG_CMD_MTD=y CONFIG_CMD_REMOTEPROC=y CONFIG_CMD_USB_MASS_STORAGE=y @@ -155,6 +155,8 @@ CONFIG_USB_XHCI_HCD=y CONFIG_USB_DWC3=y CONFIG_USB_DWC3_GENERIC=y CONFIG_SPL_USB_DWC3_GENERIC=y +CONFIG_SPL_USB_DWC3_AM62=y +CONFIG_USB_DWC3_AM62=y CONFIG_SPL_USB_STORAGE=y CONFIG_USB_GADGET=y CONFIG_SPL_USB_GADGET=y @@ -163,4 +165,3 @@ CONFIG_USB_GADGET_VENDOR_NUM=0x0451 CONFIG_USB_GADGET_PRODUCT_NUM=0x6165 CONFIG_SPL_DFU=y CONFIG_FS_FAT_MAX_CLUSTSIZE=16384 -CONFIG_TI_COMMON_CMD_OPTIONS=y -- 2.43.0
