Re: [PATCH 06/19] ARM: dts: stm32: Add alternate pinmux for MP13 MCAN1 pins

[Patrice CHOTARD]

On 4/22/24 01:16, Marek Vasut wrote:
> Add another mux option for MCAN1 pins, this is used on
> DH electronics STM32MP13xx DHCOR DHSBC board.
> 
> Signed-off-by: Marek Vasut <ma...@denx.de>
> ---
> Cc: Patrice Chotard <patrice.chot...@foss.st.com>
> Cc: Patrick Delaunay <patrick.delau...@foss.st.com>
> Cc: u-b...@dh-electronics.com
> Cc: uboot-st...@st-md-mailman.stormreply.com
> ---
>  arch/arm/dts/stm32mp13-pinctrl.dtsi | 20 ++++++++++++++++++++
>  1 file changed, 20 insertions(+)
> 
> diff --git a/arch/arm/dts/stm32mp13-pinctrl.dtsi 
> b/arch/arm/dts/stm32mp13-pinctrl.dtsi
> index cfbae71efc7..b38174504ff 100644
> --- a/arch/arm/dts/stm32mp13-pinctrl.dtsi
> +++ b/arch/arm/dts/stm32mp13-pinctrl.dtsi
> @@ -168,6 +168,26 @@
>               };
>       };
>  
> +     m_can1_pins_a: m-can1-0 {
> +             pins1 {
> +                     pinmux = <STM32_PINMUX('G', 10, AF9)>; /* CAN1_TX */
> +                     slew-rate = <1>;
> +                     drive-push-pull;
> +                     bias-disable;
> +             };
> +             pins2 {
> +                     pinmux = <STM32_PINMUX('D', 0, AF9)>; /* CAN1_RX */
> +                     bias-disable;
> +             };
> +     };
> +
> +     m_can1_sleep_pins_a: m_can1-sleep-0 {
> +             pins {
> +                     pinmux = <STM32_PINMUX('G', 10, ANALOG)>, /* CAN1_TX */
> +                              <STM32_PINMUX('D', 0, ANALOG)>; /* CAN1_RX */
> +             };
> +     };
> +
>       mcp23017_pins_a: mcp23017-0 {
>               pins {
>                       pinmux = <STM32_PINMUX('G', 12, GPIO)>;

Reviewed-by: Patrice Chotard <patrice.chot...@foss.st.com>

Thanks
Patrice