Hi Jens,

Am 23.01.24 um 12:11 schrieb Jens Maus:
Hi,

Am 22.01.2024 um 15:16 schrieb Ivan T. Ivanov <iiva...@suse.de>:

On 01-22 13:57, Ivan T. Ivanov wrote:
I was able to enable early debug UART in U-Boot and I will try to
find what is happening, once I get some free cycles.
Ok, this was relatively easy to find :-)

New versions of EEPROM firmware change “kernel”/U-Boot load address
from 0x80000 to 0x200000. And because on RPi’s CONFIG_TEXT_BASE is
hardcoded to 0x80000 code run through the fields.

Hopefully simple patch like bellow make it work fine in older and
newer EEPROM firmware versions.
Thanks for this tiny but important fix on your patchset. In fact, I was able to 
verify that now with your latest v5 patchset for the initial rpi5 support even 
newer/latest rpi-eeprom versions work as expected and u-boot is chain loaded by 
the rpi boot loader.
thank you for testing. Could you please give your Tested-by to v5 or at
least parts of them?

So thanks again for that fix and I am looking forward to seeing your patchset 
integrated and hopefully also maintained in future so that USB boot and GPIO 
support will be added in the near future.

regards,
jens

Reply via email to