[PATCH 2/3] mmc: fsl_esdhc_spl: pre-PBL: fix determining U-Boot size

[Pali Rohár]

In pre-PBL header is stored size of code which BootROM copies from SD card
to L2/SRAM. This size has upper limit of L2 cache size. In most cases this
is size of U-Boot SPL or size of L2 cache.

Therefore this size in pre-PBL header cannot be used for determining size
of proper U-Boot.

So always use CONFIG_SYS_MMC_U_BOOT_SIZE for determining size of proper
U-Boot which stored on SD card.

Signed-off-by: Pali Rohár <p...@kernel.org>
---
 drivers/mmc/fsl_esdhc_spl.c | 12 ++----------
 1 file changed, 2 insertions(+), 10 deletions(-)

diff --git a/drivers/mmc/fsl_esdhc_spl.c b/drivers/mmc/fsl_esdhc_spl.c
index 109f558dcad3..b87597a88e1d 100644
--- a/drivers/mmc/fsl_esdhc_spl.c
+++ b/drivers/mmc/fsl_esdhc_spl.c
@@ -79,7 +79,6 @@ void __noreturn mmc_boot(void)
 
 #ifdef CONFIG_FSL_CORENET
        offset = CONFIG_SYS_MMC_U_BOOT_OFFS;
-       code_len = CONFIG_SYS_MMC_U_BOOT_SIZE;
 #else
        blklen = mmc->read_bl_len;
        tmp_buf = malloc(blklen);
@@ -135,18 +134,11 @@ void __noreturn mmc_boot(void)
                offset = (offset << 8) + val;
        }
        offset += CONFIG_SYS_MMC_U_BOOT_OFFS;
-       /* Get the code size from offset 0x48 */
-       byte_num = 4;
-       code_len = 0;
-       for (i = 0; i < byte_num; i++) {
-               val = *(tmp_buf + ESDHC_BOOT_IMAGE_SIZE + i);
-               code_len = (code_len << 8) + val;
-       }
-       code_len -= CONFIG_SYS_MMC_U_BOOT_OFFS;
+#endif
        /*
        * Load U-Boot image from mmc into RAM
        */
-#endif
+       code_len = CONFIG_SYS_MMC_U_BOOT_SIZE;
        blk_start = ALIGN(offset, mmc->read_bl_len) / mmc->read_bl_len;
        blk_cnt = ALIGN(code_len, mmc->read_bl_len) / mmc->read_bl_len;
        err = mmc->block_dev.block_read(&mmc->block_dev, blk_start, blk_cnt,
-- 
2.20.1