Hi Bin, On Mon, Nov 1, 2021 at 2:16 PM Bin Meng <bmeng...@gmail.com> wrote:
> On Fri, Oct 22, 2021 at 4:58 PM Padmarao Begari > <padmarao.beg...@microchip.com> wrote: > > > > UART1 uses for U-BOOT and Linux console instead of UART0 and > > nits: s/U-BOOT/U-Boot > > ok > > UART0 is reserved for Hart Software Services(HSS). > > > > Signed-off-by: Padmarao Begari <padmarao.beg...@microchip.com> > > --- > > doc/board/microchip/mpfs_icicle.rst | 11 +++++++---- > > 1 file changed, 7 insertions(+), 4 deletions(-) > > > > diff --git a/doc/board/microchip/mpfs_icicle.rst > b/doc/board/microchip/mpfs_icicle.rst > > index c71c2f3cab..d7af542c0e 100644 > > --- a/doc/board/microchip/mpfs_icicle.rst > > +++ b/doc/board/microchip/mpfs_icicle.rst > > @@ -18,8 +18,9 @@ The support for following drivers are already enabled: > > > > 1. NS16550 UART Driver. > > 2. Microchip Clock Driver. > > -3. Cadence MACB ethernet driver for networking support. > > -4. Cadence MMC Driver for eMMC/SD support. > > +3. Microchip I2C Driver. > > nits: can we just insert this after the existing entries? > > ok Regards Padmarao > > +4. Cadence MACB ethernet driver for networking support. > > +5. Cadence MMC Driver for eMMC/SD support. > > > > Booting from eMMC using HSS > > --------------------------- > > @@ -214,7 +215,8 @@ GPT partition. > > Booting > > ~~~~~~~ > > > > -You should see the U-Boot prompt on UART0. > > +You should see the U-Boot prompt on UART1. > > +(Note: UART0 is reserved for HSS) > > > > Sample boot log from MPFS Icicle Kit > > '''''''''''''''''''''''''''''''''''' > > @@ -451,7 +453,8 @@ copied payload and Linux image. > > > > sudo dd if=<payload_binary> of=/dev/sdX2 bs=512 > > > > -You should see the U-Boot prompt on UART0. > > +You should see the U-Boot prompt on UART1. > > +(Note: UART0 is reserved for HSS) > > > > GUID type > > ~~~~~~~~~ > > Otherwise, > Reviewed-by: Bin Meng <bmeng...@gmail.com> > > Regards, > Bin >
