UART1 uses for U-BOOT and Linux console instead of UART0 and
UART0 is reserved for Hart Software Services(HSS).
Signed-off-by: Padmarao Begari <padmarao.beg...@microchip.com>
---
doc/board/microchip/mpfs_icicle.rst | 11 +++++++----
1 file changed, 7 insertions(+), 4 deletions(-)
diff --git a/doc/board/microchip/mpfs_icicle.rst
b/doc/board/microchip/mpfs_icicle.rst
index c71c2f3cab..d7af542c0e 100644
--- a/doc/board/microchip/mpfs_icicle.rst
+++ b/doc/board/microchip/mpfs_icicle.rst
@@ -18,8 +18,9 @@ The support for following drivers are already enabled:
1. NS16550 UART Driver.
2. Microchip Clock Driver.
-3. Cadence MACB ethernet driver for networking support.
-4. Cadence MMC Driver for eMMC/SD support.
+3. Microchip I2C Driver.
+4. Cadence MACB ethernet driver for networking support.
+5. Cadence MMC Driver for eMMC/SD support.
Booting from eMMC using HSS
---------------------------
@@ -214,7 +215,8 @@ GPT partition.
Booting
~~~~~~~
-You should see the U-Boot prompt on UART0.
+You should see the U-Boot prompt on UART1.
+(Note: UART0 is reserved for HSS)
Sample boot log from MPFS Icicle Kit
''''''''''''''''''''''''''''''''''''
@@ -451,7 +453,8 @@ copied payload and Linux image.
sudo dd if=<payload_binary> of=/dev/sdX2 bs=512
-You should see the U-Boot prompt on UART0.
+You should see the U-Boot prompt on UART1.
+(Note: UART0 is reserved for HSS)
GUID type
~~~~~~~~~
--
2.25.1
