On Fri, Oct 22, 2021 at 4:58 PM Padmarao Begari <padmarao.beg...@microchip.com> wrote: > > UART1 uses for U-BOOT and Linux console instead of UART0 and
nits: s/U-BOOT/U-Boot > UART0 is reserved for Hart Software Services(HSS). > > Signed-off-by: Padmarao Begari <padmarao.beg...@microchip.com> > --- > doc/board/microchip/mpfs_icicle.rst | 11 +++++++---- > 1 file changed, 7 insertions(+), 4 deletions(-) > > diff --git a/doc/board/microchip/mpfs_icicle.rst > b/doc/board/microchip/mpfs_icicle.rst > index c71c2f3cab..d7af542c0e 100644 > --- a/doc/board/microchip/mpfs_icicle.rst > +++ b/doc/board/microchip/mpfs_icicle.rst > @@ -18,8 +18,9 @@ The support for following drivers are already enabled: > > 1. NS16550 UART Driver. > 2. Microchip Clock Driver. > -3. Cadence MACB ethernet driver for networking support. > -4. Cadence MMC Driver for eMMC/SD support. > +3. Microchip I2C Driver. nits: can we just insert this after the existing entries? > +4. Cadence MACB ethernet driver for networking support. > +5. Cadence MMC Driver for eMMC/SD support. > > Booting from eMMC using HSS > --------------------------- > @@ -214,7 +215,8 @@ GPT partition. > Booting > ~~~~~~~ > > -You should see the U-Boot prompt on UART0. > +You should see the U-Boot prompt on UART1. > +(Note: UART0 is reserved for HSS) > > Sample boot log from MPFS Icicle Kit > '''''''''''''''''''''''''''''''''''' > @@ -451,7 +453,8 @@ copied payload and Linux image. > > sudo dd if=<payload_binary> of=/dev/sdX2 bs=512 > > -You should see the U-Boot prompt on UART0. > +You should see the U-Boot prompt on UART1. > +(Note: UART0 is reserved for HSS) > > GUID type > ~~~~~~~~~ Otherwise, Reviewed-by: Bin Meng <bmeng...@gmail.com> Regards, Bin