[PATCH 03/13] imx: ddr: imx8m: add print for DRAM rate

[Peng Fan (OSS)]

From: Ye Li <ye...@nxp.com>

Enable print to show the DRAM rate of current setting and training
result.

Signed-off-by: Ye Li <ye...@nxp.com>
Reviewed-by: Peng Fan <peng....@nxp.com>
Signed-off-by: Peng Fan <peng....@nxp.com>
---
 drivers/ddr/imx/imx8m/ddr_init.c     | 7 ++++---
 drivers/ddr/imx/imx8m/ddrphy_utils.c | 2 +-
 2 files changed, 5 insertions(+), 4 deletions(-)

diff --git a/drivers/ddr/imx/imx8m/ddr_init.c b/drivers/ddr/imx/imx8m/ddr_init.c
index 99a67edfb0..65739dbaa7 100644
--- a/drivers/ddr/imx/imx8m/ddr_init.c
+++ b/drivers/ddr/imx/imx8m/ddr_init.c
@@ -96,7 +96,7 @@ int ddr_init(struct dram_timing_info *dram_timing)
        unsigned int tmp, initial_drate, target_freq;
        int ret;
 
-       debug("DDRINFO: start DRAM init\n");
+       printf("DDRINFO: start DRAM init\n");
 
        /* Step1: Follow the power up procedure */
        if (is_imx8mq()) {
@@ -119,6 +119,7 @@ int ddr_init(struct dram_timing_info *dram_timing)
 
        initial_drate = dram_timing->fsp_msg[0].drate;
        /* default to the frequency point 0 clock */
+       printf("DDRINFO: DRAM rate %dMTS\n", initial_drate);
        ddrphy_init_set_dfi_clk(initial_drate);
 
        /* D-aasert the presetn */
@@ -185,7 +186,7 @@ int ddr_init(struct dram_timing_info *dram_timing)
                tmp = reg32_read(DDRPHY_CalBusy(0));
        } while ((tmp & 0x1));
 
-       debug("DDRINFO:ddrphy calibration done\n");
+       printf("DDRINFO:ddrphy calibration done\n");
 
        /* Step15: Set SWCTL.sw_done to 0 */
        reg32_write(DDRC_SWCTL(0), 0x00000000);
@@ -240,7 +241,7 @@ int ddr_init(struct dram_timing_info *dram_timing)
 
        /* enable port 0 */
        reg32_write(DDRC_PCTRL_0(0), 0x00000001);
-       debug("DDRINFO: ddrmix config done\n");
+       printf("DDRINFO: ddrmix config done\n");
 
        board_dram_ecc_scrub();
 
diff --git a/drivers/ddr/imx/imx8m/ddrphy_utils.c 
b/drivers/ddr/imx/imx8m/ddrphy_utils.c
index 0f8baefb1f..326b92d784 100644
--- a/drivers/ddr/imx/imx8m/ddrphy_utils.c
+++ b/drivers/ddr/imx/imx8m/ddrphy_utils.c
@@ -104,7 +104,7 @@ int wait_ddrphy_training_complete(void)
                        debug("Training PASS\n");
                        return 0;
                } else if (mail == 0xff) {
-                       debug("Training FAILED\n");
+                       printf("Training FAILED\n");
                        return -1;
                }
        }
-- 
2.28.0