Hello,
after enabling relocation I get the following output:
U-Boot 2010.09-00106-g6e135b9-dirty (Sep 30 2010 - 16:57:43)
U-Boot code: 21F00000 -> 21F3C140 BSS: -> 21F7D700
CPU: AT91SAM9XE
Crystal frequency: 18.432 MHz
CPU clock : 198.656 MHz
Master clock : 99.328 MHz
I2C: ready
monitor len: 0007D700 <<<< this must be wrong, the binary is short of 256k large
ramsize: 04000000 <<<< correct
Top of RAM usable for U-Boot at: 24000000 <<<< correct
Reserving 501k for U-Boot at: 23f82000
Reserving 143k for malloc() at: 23f5e100
Reserving 24 Bytes for Board Info at: 23f5e0e8
Reserving 88 Bytes for Global Data at: 23f5e090
New Stack Pointer is: 23f5e088
RAM Configuration:
Bank #0: 20000000 64 MiB <<< correct
relocation Offset is: 02082000 <<<< could be right
<<< system hangs here >>>
Details: initial bootstrap loads u-boot to RAM at 21f00000
(1MiB short of 32 MiB which is the minimum RAM populated)
I have set the following values:
#define CONFIG_SKIP_LOWLEVEL_INIT
#define CONFIG_SKIP_RELOCATE_UBOOT
/*#define CONFIG_SYS_ARM_WITHOUT_RELOC*/
#define CONFIG_SYS_NO_ICACHE
#define CONFIG_SYS_NO_DCACHE
and
/* SDRAM: min 32, upto 128 MB */
#define CONFIG_NR_DRAM_BANKS 1
#define PHYS_SDRAM 0x20000000
#define PHYS_SDRAM_MAX_SIZE 0x08000000
#define CONFIG_SYS_MEMTEST_START PHYS_SDRAM
#define CONFIG_SYS_MEMTEST_END 0x21e00000
#define CONFIG_SYS_LOAD_ADDR (PHYS_SDRAM+0x01000000) /* 16 MB into
RAM */
#define CONFIG_SYS_SDRAM_BASE PHYS_SDRAM
#define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_SDRAM_BASE + 0x1000 -
CONFIG_SYS_GBL_DATA_SIZE)
and in config.mk:
TEXT_BASE = 0x21f00000
and
int dram_init(void)
{
gd->ram_size =
get_ram_size((void*)PHYS_SDRAM, PHYS_SDRAM_MAX_SIZE);
return 0;
}
void dram_init_banksize(void)
{
gd->bd->bi_dram[0].start = PHYS_SDRAM;
gd->bd->bi_dram[0].size =
get_ram_size((void*)PHYS_SDRAM, PHYS_SDRAM_MAX_SIZE);
}
I do probably have a simple misunderstanding of the concept.
1. should CONFIG_SKIP_RELOCATE_UBOOT be not defined anymore?
2. TEXT_BASE must be the address where the u-boot is loaded
by 1st loader and startet, right?
With Best Regards,
Reinhard
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
