Hello Reinhard, Reinhard Meyer wrote: > Dear Stefano Babic, >>> 1. should CONFIG_SKIP_RELOCATE_UBOOT be not defined anymore? >> I had the same issue because I forget to remove it from my config file. >> After dropping it, I got the u-boot prompt again ;-) > Thank you, that (partially) helped: > > U-Boot 2010.09-00106-g6e135b9-dirty (Sep 30 2010 - 17:32:36) > > U-Boot code: 21F00000 -> 21F3C180 BSS: -> 21F7D700 > CPU: AT91SAM9XE > Crystal frequency: 18.432 MHz > CPU clock : 198.656 MHz > Master clock : 99.328 MHz > I2C: ready > monitor len: 0007D700 > ramsize: 04000000 > Top of RAM usable for U-Boot at: 24000000 > Reserving 501k for U-Boot at: 23f82000 > Reserving 143k for malloc() at: 23f5e100 > Reserving 24 Bytes for Board Info at: 23f5e0e8 > Reserving 88 Bytes for Global Data at: 23f5e090 > New Stack Pointer is: 23f5e088 > RAM Configuration: > Bank #0: 20000000 64 MiB > relocation Offset is: 02082000 > monitor flash len: 0003C180 > Now running in RAM - U-Boot at: 23f82000 > FLASH: 512 KiB > NAND: raise: Signal # 8 caught > raise: Signal # 8 caught > raise: Signal # 8 caught > 256 MiB > *** Warning - bad CRC, using default environment > > In: serial > Out: serial > Err: serial > MMC: mci: 0 > Net: macb0, enc1.0, enc1.1, enc1.2 > Reset Ethernet PHY > macb0: Starting autonegotiation... > macb0: Autonegotiation timed out (status=0x7849) > macb0: link down (status: 0x7849) > enc1.0: timeout waiting for CLKRDY > enc1.1: timeout waiting for CLKRDY > enc1.2: timeout waiting for CLKRDY > Press SPACE to abort autoboot in 1 seconds > > Before the relocation: macb, enc and environment did work :) > I have to look into that issue later...
No spontaneous idea ... maybe something with gpio pins? bye, Heiko -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
