> -----Original Message----- > From: u-boot-boun...@lists.denx.de > [mailto:u-boot-boun...@lists.denx.de] On Behalf Of Wolfgang Denk > Sent: Saturday, August 07, 2010 9:18 PM > To: Sergei Trofimovich > Cc: u-boot@lists.denx.de > Subject: Re: [U-Boot] 'usb start' works very unstable > > Dear Sergei Trofimovich, > > In message <20100807163957.52c1c...@mosly> you wrote: > > > > > > Heh, capacity is reported incorrectly, but it works am I'm able > > > > to load kernel from there. > > > The reason for this is that the multiplication 488397168 > x 512 will > > > overflow a 32 bit integer as used in "disk/part.c"; this shouldbe > > > fixed... > > > > This issue is still here: > > Sorry for not being clear. What I meant was: this is a bug that needs > to be fixed (patches welcome). > > > > And I can't reproduce it anymore with 'u-boot/master'. > > Rebooted 3 times and I have stable detection \o/. > > Good. At least one problem solved. > > > $sudo openocd -f /usr/share/openocd/scripts/board/sheevaplug.cfg > > Open On-Chip Debugger 0.5.0-dev-00466-g28ddefd > (2010-08-06-22:54) > > ... > > > reset > > Hm... I am not sure what exactly the OpenOCD debugger does when you > run the reset command; eventually it performs some initializations > (defined in sheevaplug.cfg ?), and/or prevents others. The CPU may, or > may not, be in the virgin state expected by U-Boot.
It just perform system reset operation and resumes operation normally unless we halt if through debug commands Regards.. Prafulla . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
