Dear Sergei Trofimovich, In message <20100807163957.52c1c...@mosly> you wrote: > > > > Heh, capacity is reported incorrectly, but it works am I'm able > > > to load kernel from there. > > The reason for this is that the multiplication 488397168 x 512 will > > overflow a 32 bit integer as used in "disk/part.c"; this shouldbe > > fixed... > > This issue is still here:
Sorry for not being clear. What I meant was: this is a bug that needs to be fixed (patches welcome). > And I can't reproduce it anymore with 'u-boot/master'. > Rebooted 3 times and I have stable detection \o/. Good. At least one problem solved. > $sudo openocd -f /usr/share/openocd/scripts/board/sheevaplug.cfg > Open On-Chip Debugger 0.5.0-dev-00466-g28ddefd (2010-08-06-22:54) > ... > > reset Hm... I am not sure what exactly the OpenOCD debugger does when you run the reset command; eventually it performs some initializations (defined in sheevaplug.cfg ?), and/or prevents others. The CPU may, or may not, be in the virgin state expected by U-Boot. Detach the debugger, and perform a real hard reset instead. Or try to configure the debugger not to perform any initializations (i. e. the equivalent of the "reset run" command on BDI2000/30000). Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de Democracy is mob rule, but with income taxes. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
