> -----Original Message----- > From: u-boot-boun...@lists.denx.de > [mailto:u-boot-boun...@lists.denx.de] On Behalf Of Albert Aribaud > Sent: Thursday, August 05, 2010 6:06 PM > To: u-boot@lists.denx.de > Subject: [U-Boot] [PATCH V7 4/4] edminiv2: add mvsata_ide and > cmd_ide support > > Add mvsata_ide and cmd_ide configuration in edminiv2 config > > Signed-off-by: Albert Aribaud <albert.arib...@free.fr> > --- > include/configs/edminiv2.h | 34 +++++++++++++++++++++++++++++++++- > 1 files changed, 33 insertions(+), 1 deletions(-) > > diff --git a/include/configs/edminiv2.h b/include/configs/edminiv2.h > index 055931c..57dd165 100644 > --- a/include/configs/edminiv2.h > +++ b/include/configs/edminiv2.h > @@ -60,7 +60,7 @@ > > #define ORION5X_MPP0_7 0x00000003 > #define ORION5X_MPP8_15 0x55550000 > -#define ORION5X_MPP16_23 0x00000000 > +#define ORION5X_MPP16_23 0x00005555 > > /* > * Board-specific values for Orion5x GPIO low level init: > @@ -131,6 +131,7 @@ > * Commands configuration - using default command set for now > */ > #include <config_cmd_default.h> > +#define CONFIG_CMD_IDE > > /* > * Network > @@ -150,6 +151,37 @@ > #endif > > /* > + * IDE > + */ > +#ifdef CONFIG_CMD_IDE > +#define __io > +#define CONFIG_IDE_PREINIT > +#define CONFIG_DOS_PARTITION > +#define CONFIG_CMD_EXT2 > +/* ED Mini V has an IDE-compatible SATA connector for port 1 */ > +#define CONFIG_MVSATA_IDE > +#define CONFIG_MVSATA_IDE_USE_PORT1 > +/* Needs byte-swapping for ATA data register */ > +#define CONFIG_IDE_SWAP_IO > +/* Data, registers and alternate blocks are at the same offset */ > +#define CONFIG_SYS_ATA_DATA_OFFSET (0x0100) > +#define CONFIG_SYS_ATA_REG_OFFSET (0x0100) > +#define CONFIG_SYS_ATA_ALT_OFFSET (0x0100) > +/* Each 8-bit ATA register is aligned to a 4-bytes address */ > +#define CONFIG_SYS_ATA_STRIDE 4 > +/* Controller supports 48-bits LBA addressing */ > +#define CONFIG_LBA48 > +/* A single bus, a single device */ > +#define CONFIG_SYS_IDE_MAXBUS 1 > +#define CONFIG_SYS_IDE_MAXDEVICE 1 > +/* ATA registers base is at SATA controller base */ > +#define CONFIG_SYS_ATA_BASE_ADDR ORION5X_SATA_BASE > +/* ATA bus 0 is orion5x port 1 on ED Mini V2 */ > +#define CONFIG_SYS_ATA_IDE0_OFFSET ORION5X_SATA_PORT1_OFFSET > +/* end of IDE defines */ > +#endif /* CMD_IDE */ > + > +/* > * Environment variables configurations > */ > #define CONFIG_ENV_IS_IN_FLASH 1 > --
Acked-by: Prafulla Wadaskar <prafu...@marvell.com> Regards.. Prafulla . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
