With the current code, it is not possible to assign different than default
numbers for mmc controllers.
Several in-tree boards depend on the pre-dm setup, corresponding to
following aliases:
mmc0 = &usdhc2; --> fsl,usdhc-index = <1>
mmc1 = &usdhc4; --> fsl,usdhc-index = <3>
Without this patch we are either forced to use default aliasing - like:
mmc0 = &usdhc1;
mmc1 = &usdhc2;
mmc2 = &usdhc3;
mmc3 = &usdhc4;
to have the proper clocks setup for the controller. However, such setup
is not acceptable for some legacy scripts / code.
With this patch - by introducing 'fsl,usdhc-index' - one can configure
(get) clock rate corresponding to used controller.
Moreover, as this code is used in the SPL before relocation (and to save
space we strip the SPL DTS from clocks and its names) adding separate
properties seems to be the best approach here. One also avoids adding
clocks DM code to SPL.
Signed-off-by: Lukasz Majewski <lu...@denx.de>
---
drivers/mmc/fsl_esdhc.c | 17 ++++++++++++++++-
1 file changed, 16 insertions(+), 1 deletion(-)
diff --git a/drivers/mmc/fsl_esdhc.c b/drivers/mmc/fsl_esdhc.c
index 3cdfa7f5a6..49a6834a98 100644
--- a/drivers/mmc/fsl_esdhc.c
+++ b/drivers/mmc/fsl_esdhc.c
@@ -1401,6 +1401,7 @@ static int fsl_esdhc_probe(struct udevice *dev)
fdt_addr_t addr;
unsigned int val;
struct mmc *mmc;
+ int usdhc_idx;
int ret;
addr = dev_read_addr(dev);
@@ -1513,7 +1514,21 @@ static int fsl_esdhc_probe(struct udevice *dev)
priv->sdhc_clk = clk_get_rate(&priv->per_clk);
} else {
- priv->sdhc_clk = mxc_get_clock(MXC_ESDHC_CLK + dev->seq);
+ /*
+ * Check for 'fsl,index' DTS property - as one may want to have
+ * following mmc setup:
+ * mmc0 = &usdhc2; --> fsl,index = <1>
+ * mmc1 = &usdhc4; --> fsl,index = <3>
+ *
+ * So we do have dev->seq = {0, 1}, which in the below code
+ * doesn't correspond to correct USDHC clocks.
+ *
+ * For that reason a new "fsl,index" property has been
+ * introduced.
+ */
+ usdhc_idx = dev_read_u32_default(dev, "fsl,usdhc-index",
+ dev->seq);
+ priv->sdhc_clk = mxc_get_clock(MXC_ESDHC_CLK + usdhc_idx);
if (priv->sdhc_clk <= 0) {
dev_err(dev, "Unable to get clk for %s\n", dev->name);
return -EINVAL;
--
2.11.0
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
