+ Adam On Mon, Dec 10, 2018 at 4:23 PM Patrick Delaunay <patrick.delau...@st.com> wrote: > > In case of DT boot, don't read default speed and mode for SPI from > CONFIG_*, instead read from DT node. > > Signed-off-by: Patrick Delaunay <patrick.delau...@st.com> > --- > > board/davinci/da8xxevm/da850evm.c | 7 +++++++ > 1 file changed, 7 insertions(+) > > diff --git a/board/davinci/da8xxevm/da850evm.c > b/board/davinci/da8xxevm/da850evm.c > index b0b29b3..4ef454e 100644 > --- a/board/davinci/da8xxevm/da850evm.c > +++ b/board/davinci/da8xxevm/da850evm.c > @@ -44,8 +44,15 @@ DECLARE_GLOBAL_DATA_PTR; > > #define CFG_MAC_ADDR_SPI_BUS 0 > #define CFG_MAC_ADDR_SPI_CS 0 > + > +#ifdef CONFIG_DM_SPI_FLASH > +/* In DM mode, speed and mode value will be taken from DT */ > +#define CFG_MAC_ADDR_SPI_MAX_HZ 0 > +#define CFG_MAC_ADDR_SPI_MODE 0 > +#else > #define CFG_MAC_ADDR_SPI_MAX_HZ CONFIG_SF_DEFAULT_SPEED > #define CFG_MAC_ADDR_SPI_MODE SPI_MODE_3 > +#endif
This board support DM_SPI_FLASH even in for SPL, so there is no need of non-dm if here. _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
