Tried with loady command in u-boot and ymodem option from minicom. With this combination I am able to transfer and run uImage.
~cnanda On Sat, Jan 30, 2010 at 10:02 PM, Wolfgang Denk <w...@denx.de> wrote: > Dear Chetan Nanda, > > In message <7f245da81001300735x6d0727f8s2f530d6a3540e...@mail.gmail.com> > you wrote: > > > > Every time after this transfer get started but then aborted automatically > > with following error message: > ... > > HINTS... If the preceding error message does not explain the failure: > > . Try changing the remote Kermit's FLOW-CONTROL setting. > > . Increase the retry limit (see HELP SET RETRY). > > . Try it again with SET STREAMING OFF. > > . Try it again with SET PARITY SPACE. > > . As a last resort, give a ROBUST command and try again. > > So - have you tried any of these hints? > > The kermit developer tried the best they could do to help you by > providing valuable hints for configuration settings that might help to > solve your problem - and did you follow their advice? > > Also, did you RTFM? The manual contains a section on how to configure > kermit for reliable work: > > http://www.denx.de/wiki/view/DULG/SystemSetup#Section_4.3. > > Did you really adapt your ~/.kermrc as recommended? > > Best regards, > > Wolfgang Denk > > -- > DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel > HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany > Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de > "Bureaucracy is the enemy of innovation." > - Mark Shepherd, former President and CEO of Texas Instruments >
_______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
