Dear Hemant, In message <2a3dcf3da181ad40bde86a3150b27b6b03097ec...@dbde02.ent.ti.com> you wrote: > > Any suggestions on this?
Well, the best solution would obviously be to fix the hardware... > > There is no abort on ARM and also nothing gets to the console when UART > > register is accessed. Then what exactly is happening on your hardware when you read the register? Did you really try out all options, i. e. reading as a 8 bit access with 0, 1, 2 and 3 bytes offset, etc.? If you don't see any ecxceptions, then these accesses must be somehow visible on the bus. Find out (using a scope / logic analyzer) which byte lanes get accessed when, and show us a table here what happens when. Only after we understand what is happening on your system we can come up with any recommendations. Best regards, Wolfgang Denk -- DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de Alliance: In international politics, the union of two thieves who have their hands so deeply inserted in each other's pocket that they cannot separately plunder a third. - Ambrose Bierce _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
