Hi Alex, On 01.04.2018 11:22, Alex Kiernan wrote: > This converts CONFIG_DRIVER_TI_CPSW to Kconfig > > Signed-off-by: Alex Kiernan <alex.kier...@gmail.com> > Acked-by: Joe Hershberger <joe.hershber...@ni.com> > --- > > Changes in v2: > - Move DRIVER_TI_CPSW outside of the NETDEVICES guard > - Don't mark DRIVER_TI_CPSW default if ARCH_OMAP2PLUS to fix mistranslations > by moveconfig >
[..] > diff --git a/configs/am335x_pdu001_defconfig b/configs/am335x_pdu001_defconfig > index cb75ec0..87ae88c 100644 > --- a/configs/am335x_pdu001_defconfig > +++ b/configs/am335x_pdu001_defconfig > @@ -9,13 +9,13 @@ CONFIG_SPL_SERIAL_SUPPORT=y > CONFIG_SPL_LIBDISK_SUPPORT=y > # CONFIG_SPL_NAND_SUPPORT is not set > CONFIG_SPL_WATCHDOG_SUPPORT=y > +CONFIG_SPL=y > CONFIG_SPL_FAT_SUPPORT=y > CONFIG_DEFAULT_DEVICE_TREE="am335x-pdu001" > CONFIG_LOCALVERSION="-EETS-1.0.0" > CONFIG_DISTRO_DEFAULTS=y > CONFIG_BOOTDELAY=1 > # CONFIG_USE_BOOTCOMMAND is not set > -CONFIG_SPL=y > # CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR is not set > CONFIG_SPL_I2C_SUPPORT=y > CONFIG_SPL_YMODEM_SUPPORT=y > @@ -39,6 +39,7 @@ CONFIG_DM_GPIO=y > CONFIG_DM_I2C=y > CONFIG_MMC_OMAP_HS=y > CONFIG_MMC_SDHCI=y > +CONFIG_DRIVER_TI_CPSW=y Applying this patch series generates the following warning while creating the default configuration for board PDU001: warning: (BOARD_SPECIFIC_OPTIONS && BOARD_SPECIFIC_OPTIONS && BOARD_SPECIFIC_OPTIONS && BOARD_SPECIFIC_OPTIONS && DRIVER_TI_CPSW && AG7XXX && ALTERA_TSE && BCM_SF2_ETH && DWC_ETH_QOS && ETH_DESIGNWARE && MVNETA && MVPP2 && MACB && PCH_GBE && SUN4I_EMAC && SUN8I_EMAC && SH_ETHER && XILINX_AXIEMAC && XILINX_EMACLITE && ZYNQ_GEM && PIC32_ETH && RENESAS_RAVB) selects PHYLIB which has unmet direct dependencies (NET) This is due to the patch enabling CONFIG_DRIVER_TI_CPSW while leaving CONFIG_NET disabled. This board does not require/have network support for U-Boot so there is no need or benefit activating CONFIG_DRIVER_TI_CPSW here. Leaving the file configs/am355x_pdu001_defconfig without any modifications will make your patch work properly and result in a clean, warning and error free, build for the PDU001 board. > CONFIG_PINCTRL=y > CONFIG_PINCTRL_SINGLE=y > CONFIG_DM_PMIC=y regards, Felix _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot