Hi Jaehoon, On 30 July 2017 at 20:46, Jaehoon Chung <jh80.ch...@samsung.com> wrote: > Hi Simon, > > On 07/28/2017 11:40 PM, Simon Glass wrote: >> Hi Jaehoon, >> >> On 28 July 2017 at 06:25, Jaehoon Chung <jh80.ch...@samsung.com> wrote: >>> Dear Simon, >>> >>> On 07/27/2017 11:43 AM, Jaehoon Chung wrote: >>>> On 07/23/2017 02:15 AM, Simon Glass wrote: >>>>> (pruning the cc list a bit) >>>>> >>>>> Hi Jaehoon, >>>>> >>>>> On 4 July 2017 at 13:48, Simon Glass <s...@chromium.org> wrote: >>>>>> This series completes the conversion of SATA to driver model. >>>>>> >>>>>> Previous work converted SCSI including the SCSI-based SATA driver. This >>>>>> series converts the AHCI uclass itself, adding operations and adjusting >>>>>> the 'sata' command to work correctly. >>>>>> >>>>>> An existing board (Compulab Utilite) is used for this work. It uses SATA >>>>>> without the SCSI layer. Unfortunately this board does not currently use >>>>>> driver model for MMC or USB, nor does it include a device tree. Therefore >>>>>> additional patches are included in this series to convert this over. Note >>>>>> that USB is rendered inoperative since the relevant device-tree nodes are >>>>>> disabled. Further work is needed here (e.g. by the board maintainer) but >>>>>> it is well beyond the objective of this series. >>>>>> >>>>>> A long-standing niggle with MMC has been the CONFIG_DM_MMC_OPS option. >>>>>> This was introduced to allow driver model to handle MMC operations rather >>>>>> than having them in struct mmc. This was needed since the original uclass >>>>>> did not have support for operations. >>>>>> >>>>>> At present i.MX is the only SoC that defines CONFIG_DM_MMC without >>>>>> CONFIG_DM_MMC_OPS. With this driver converted, the option is no longer >>>>>> necessary so this series takes the opportunity to drop that option. >>>>> >>>>> Are you planning to review / apply this series please? It is assigned >>>>> to you in patchwork. I'd like to resolve this because I have two other >>>>> series depending on it >>>> >>>> Sorry..I had holidays..will check this week. >>> >>> Apologized for late..I'm checking this patchset and testing with my board. >>> (But there is some conflict...so i needs to check more...what i missed.) >> >> If you like I could rebase it and resend. The series is at >> u-boot-dm/ata2-working. > > Thanks for resending v2!
Do you think this can go in soon? Are there any problems / comments to address? We are already after rc1 so I am getting a bit nervous! Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
