(pruning the cc list a bit) Hi Jaehoon,
On 4 July 2017 at 13:48, Simon Glass <s...@chromium.org> wrote: > This series completes the conversion of SATA to driver model. > > Previous work converted SCSI including the SCSI-based SATA driver. This > series converts the AHCI uclass itself, adding operations and adjusting > the 'sata' command to work correctly. > > An existing board (Compulab Utilite) is used for this work. It uses SATA > without the SCSI layer. Unfortunately this board does not currently use > driver model for MMC or USB, nor does it include a device tree. Therefore > additional patches are included in this series to convert this over. Note > that USB is rendered inoperative since the relevant device-tree nodes are > disabled. Further work is needed here (e.g. by the board maintainer) but > it is well beyond the objective of this series. > > A long-standing niggle with MMC has been the CONFIG_DM_MMC_OPS option. > This was introduced to allow driver model to handle MMC operations rather > than having them in struct mmc. This was needed since the original uclass > did not have support for operations. > > At present i.MX is the only SoC that defines CONFIG_DM_MMC without > CONFIG_DM_MMC_OPS. With this driver converted, the option is no longer > necessary so this series takes the opportunity to drop that option. Are you planning to review / apply this series please? It is assigned to you in patchwork. I'd like to resolve this because I have two other series depending on it Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de https://lists.denx.de/listinfo/u-boot
