From: Daniel Schwierzeck <daniel.schwierz...@gmail.com>
All MIPS boards that support debug uart are calling debug_uart_init right at
the beginning of board_early_init_f.
Instead of doing that, let's provide a generic call to debug_uart_init right
before the call to board_init_f if debug uart is enabled for boards without
stack in SRAM.
On the other hand, boards with stack in SRAM can call earlier (right before
low level init).
Signed-off-by: Daniel Schwierzeck <daniel.schwierz...@gmail.com>
Signed-off-by: Álvaro Fernández Rojas <nolt...@gmail.com>
---
v2: Introduce the changes suggested by Daniel Schwierzeck:
- Call debug_uart_init before low level init for boards with stack in SRAM.
arch/mips/cpu/start.S | 14 ++++++++++++++
1 file changed, 14 insertions(+)
diff --git a/arch/mips/cpu/start.S b/arch/mips/cpu/start.S
index 6740fdf..a6b7a04 100644
--- a/arch/mips/cpu/start.S
+++ b/arch/mips/cpu/start.S
@@ -237,6 +237,13 @@ wr_done:
#ifdef CONFIG_MIPS_INIT_STACK_IN_SRAM
/* Set up initial stack and global data */
setup_stack_gd
+
+# ifdef CONFIG_DEBUG_UART
+ /* Earliest point to set up debug uart */
+ PTR_LA t9, debug_uart_init
+ jalr t9
+ nop
+# endif
#endif
#ifndef CONFIG_SKIP_LOWLEVEL_INIT
@@ -263,6 +270,13 @@ wr_done:
#ifndef CONFIG_MIPS_INIT_STACK_IN_SRAM
/* Set up initial stack and global data */
setup_stack_gd
+
+# ifdef CONFIG_DEBUG_UART
+ /* Earliest point to set up debug uart */
+ PTR_LA t9, debug_uart_init
+ jalr t9
+ nop
+# endif
#endif
move a0, zero # a0 <-- boot_flags = 0
--
2.1.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
https://lists.denx.de/listinfo/u-boot
