The sunxi SPL was holding the detected RAM size in some local variable
only, so it wasn't accessible for other functions.
Store the value in gd->ram_size instead, so it can be used later on.
Signed-off-by: Andre Przywara <andre.przyw...@arm.com>
---
board/sunxi/board.c | 7 +++----
1 file changed, 3 insertions(+), 4 deletions(-)
diff --git a/board/sunxi/board.c b/board/sunxi/board.c
index b966012..a510422 100644
--- a/board/sunxi/board.c
+++ b/board/sunxi/board.c
@@ -480,7 +480,6 @@ void i2c_init_board(void)
void sunxi_board_init(void)
{
int power_failed = 0;
- unsigned long ramsize;
#ifdef CONFIG_SY8106A_POWER
power_failed = sy8106a_set_vout1(CONFIG_SY8106A_VOUT1_VOLT);
@@ -541,9 +540,9 @@ void sunxi_board_init(void)
#endif
#endif
printf("DRAM:");
- ramsize = sunxi_dram_init();
- printf(" %d MiB\n", (int)(ramsize >> 20));
- if (!ramsize)
+ gd->ram_size = sunxi_dram_init();
+ printf(" %d MiB\n", (int)(gd->ram_size >> 20));
+ if (!gd->ram_size)
hang();
/*
--
2.8.2
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/listinfo/u-boot
