On 07/02/17 05:22, Lokesh Vutla wrote:
>
>
> On 2/6/2017 3:06 PM, Roger Quadros wrote:
>> PRU ethernet MAC address range is present in the
>> board EEPROM. Parse it and setup eth?addr
>> environment variables.
>>
>> Signed-off-by: Roger Quadros <rog...@ti.com>
>> Reviewed-by: Lokesh Vutla <lokeshvu...@ti.com>
>> ---
>> board/ti/ks2_evm/board_k2g.c | 19 +++++++++++++++++++
>> 1 file changed, 19 insertions(+)
>>
>> diff --git a/board/ti/ks2_evm/board_k2g.c b/board/ti/ks2_evm/board_k2g.c
>> index 40edbaa..a738dd2 100644
>> --- a/board/ti/ks2_evm/board_k2g.c
>> +++ b/board/ti/ks2_evm/board_k2g.c
>> @@ -12,6 +12,7 @@
>> #include <asm/arch/psc_defs.h>
>> #include <asm/arch/mmc_host_def.h>
>> #include "mux-k2g.h"
>> +#include "../common/board_detect.h"
>>
>> #define SYS_CLK 24000000
>>
>> @@ -149,6 +150,24 @@ int board_early_init_f(void)
>> }
>> #endif
>>
>> +#ifdef CONFIG_BOARD_LATE_INIT
>> +int board_late_init(void)
>> +{
>> +#if !defined(CONFIG_SPL_BUILD) && defined(CONFIG_TI_I2C_BOARD_DETECT)
>
> You might want to select CONFIG_TI_I2C_BOARD_DETECT and
> CONFIG_BOARD_LATE_INIT for this to take effect. I do not see these
> configs enabled or am I missing something?
I was expecting k2g-ice board to have a new defconfig. But it seems that
we will continue to use k2g_evm_defconfig for that so I'll enable these
options there.
cheers,
-roger
>
> Thanks and regards,
> Lokesh
>
>> + int rc;
>> +
>> + rc = ti_i2c_eeprom_am_get(CONFIG_EEPROM_BUS_ADDRESS,
>> + CONFIG_EEPROM_CHIP_ADDRESS);
>> + if (rc)
>> + printf("ti_i2c_eeprom_init failed %d\n", rc);
>> +
>> + board_ti_set_ethaddr(1);
>> +#endif
>> +
>> + return 0;
>> +}
>> +#endif
>> +
>> #ifdef CONFIG_SPL_BUILD
>> void spl_init_keystone_plls(void)
>> {
>>
--
cheers,
-roger
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
