Hi Roger,
On 02/06/17 11:36, Roger Quadros wrote:
> PRU ethernet MAC address range is present in the
> board EEPROM. Parse it and setup eth?addr
> environment variables.
>
> Signed-off-by: Roger Quadros <rog...@ti.com>
> Reviewed-by: Lokesh Vutla <lokeshvu...@ti.com>
> ---
> board/ti/ks2_evm/board_k2g.c | 19 +++++++++++++++++++
> 1 file changed, 19 insertions(+)
>
> diff --git a/board/ti/ks2_evm/board_k2g.c b/board/ti/ks2_evm/board_k2g.c
> index 40edbaa..a738dd2 100644
> --- a/board/ti/ks2_evm/board_k2g.c
> +++ b/board/ti/ks2_evm/board_k2g.c
> @@ -12,6 +12,7 @@
> #include <asm/arch/psc_defs.h>
> #include <asm/arch/mmc_host_def.h>
> #include "mux-k2g.h"
> +#include "../common/board_detect.h"
>
> #define SYS_CLK 24000000
>
> @@ -149,6 +150,24 @@ int board_early_init_f(void)
> }
> #endif
>
> +#ifdef CONFIG_BOARD_LATE_INIT
> +int board_late_init(void)
> +{
> +#if !defined(CONFIG_SPL_BUILD) && defined(CONFIG_TI_I2C_BOARD_DETECT)
> + int rc;
> +
> + rc = ti_i2c_eeprom_am_get(CONFIG_EEPROM_BUS_ADDRESS,
> + CONFIG_EEPROM_CHIP_ADDRESS);
> + if (rc)
> + printf("ti_i2c_eeprom_init failed %d\n", rc);
> +
> + board_ti_set_ethaddr(1);
What if the MAC address has already been set in the environment?
AFAIR, the MAC address in the environment has a higher precedence
than others.
May be I missed this, but I don't remember any discussion about changing
this assumption.
So, if the assumption is still correct, you shouldn't change the MAC in the env.
> +#endif
> +
> + return 0;
> +}
> +#endif
> +
> #ifdef CONFIG_SPL_BUILD
> void spl_init_keystone_plls(void)
> {
>
--
Regards,
Igor.
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
