At present all 16/32-bit init is controlled by CONFIG_X86_RESET_VECTOR. If this is enabled, then U-Boot is the 'first' boot loader and handles execution from the reset vector through to U-Boot's command prompt. If it is not enabled then U-Boot starts at the 32-bit entry and skips most of its init, assuming that the previous boot loader has done this already.
With the move to suport 64-bit operation, we have more cases to consider. The 16-bit and 32-bit init may be in SPL rather than in U-Boot proper. Add Kconfig options which control the location of the 16-bit and the 32-bit init. These are not intended to be user-setting except for experimentation. Their values should be determined by whether 64-bit U-Boot is used. Signed-off-by: Simon Glass <s...@chromium.org> --- arch/x86/Kconfig | 39 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 39 insertions(+) diff --git a/arch/x86/Kconfig b/arch/x86/Kconfig index 0505f97..24d8f4f 100644 --- a/arch/x86/Kconfig +++ b/arch/x86/Kconfig @@ -135,6 +135,45 @@ config X86_RESET_VECTOR bool default n +# The following options control where the 16-bit and 32-bit init lies +# If SPL is enabled then it normally holds this init code, and U-Boot proper +# is normally a 64-bit build. +# +# The 16-bit init refers to the reset vector and the small amount of code to +# get the processor into 32-bit mode. It may be in SPL or in U-Boot proper, +# or missing altogether if U-Boot is started from EFI or coreboot. +# +# The 32-bit init refers to processor init, running binary blobs including +# FSP, setting up interrupts and anything else that needs to be done in +# 32-bit code. It is normally in the same place as 32-bit init. +config X86_16BIT_INIT + bool + depends on X86_RESET_VECTOR + default y if X86_RESET_VECTOR && !SPL + help + This is enabled when 16-bit init is in U-Boot proper + +config SPL_X86_16BIT_INIT + bool + depends on X86_RESET_VECTOR + default y if X86_RESET_VECTOR && SPL + help + This is enabled when 16-bit init is in SPL + +config X86_32BIT_INIT + bool + depends on X86_RESET_VECTOR + default y if X86_RESET_VECTOR && !SPL + help + This is enabled when 32-bit init is in U-Boot proper + +config SPL_X86_32BIT_INIT + bool + depends on X86_RESET_VECTOR + default y if X86_RESET_VECTOR && SPL + help + This is enabled when 32-bit init is in SPL + config RESET_SEG_START hex depends on X86_RESET_VECTOR -- 2.8.0.rc3.226.g39d4020 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot