Dear Scott Wood,
In message <20090911222349.ga26...@b07421-ec1.am.freescale.net> you wrote:
> On Mon, Sep 07, 2009 at 12:15:22AM +0100,
> kevin.morf...@fearnside-systems.co.uk wrote:
> > This patch re-formats the arm920t s3c24x0 nand driver in preparation for
> > changes
> > to add support for the Embest SBC2440-II Board.
> >
> > The changes are as follows:
> > - re-indent the code using Lindent
> > - make sure register layouts are defined using a C struct
> > - replace the upper-case typedef'ed C struct names with lower case
> > non-typedef'ed ones
> > - make sure registers are accessed using the proper accessor functions
> > - run checkpatch.pl and fix any error reports
> >
> > It assumes the following patch has been applied first:
> > - [U-Boot][PATCH-ARM] CONFIG_SYS_HZ fix for ARM902T S3C24X0 Boards,
> > 05/09/2009
> > - patches 1/4, 2/4 and 3/4 of this series
>
> Acked-by: Scott Wood <scottw...@freescale.com>
What does that ACK mean? Who is supposed to apply this patch - the ARM
custodian?
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: w...@denx.de
The moral of the story is: "Don't stop to tighten your shoe laces
during the Olympics 100m finals".
- Kevin Jones in <dejo68....@bri.hp.com>
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
