> -----Original Message----- > From: Simon Kagstrom [mailto:simon.kagst...@netinsight.net] > Sent: Monday, September 21, 2009 4:24 PM > To: U-Boot ML > Cc: Prafulla Wadaskar; Dhaval Vasa; Prabhanjan Sarnaik; Ashish Karkare > Subject: Re: [U-Boot] [PATCH v4] Support for the OpenRD base board > > The implementation is borrowed from the sheevaplug board and > the Marvell > 1.1.4 code. Unsupported (or untested) is the SD card, PCIe and SATA. > > Signed-off-by: Simon Kagstrom <simon.kagst...@netinsight.net> > --- > I get run-time problems when building for armv5te for OpenRD base > (apparently the same problem occurs for other Kirkwood boards). > > > ChangeLog: > > v2: kwbimage.cfg, which is needed to produce an image to > install on the > NAND flash, has been added > v3: Updated after Prafullas review: > * Correct typo in comment section :-) > * Update copyright references > * Correct bit meaning in kwbimage.cfg according to new specification > * Add empty line after MPP configuration > * Use short name for board identity string in config > * Use CONFIG_SHEEVA_88SV131 instead of Feroceon > * Add CONFIG_KIRKWOOD_PCIE_INIT to config > * Use config_cmd_default.h and remove options which are not > needed anymore > * Move config address to 0x60000 (384KB). I'd like it at > this address since > adding UBI/UBIFS support to U-boot makes the binary a bit > more than 300KB > and would thus overlap a config address at 0x40000. > Not updated in v3: > * The default MTD options are kept (useful for UBIFS) > * eth init is not done, this needs to be done in a generic way > v4: Updated after Prafullas second review: > * Remove the double title line > * Change the description to note what's not tested > * Re-enable UBIFS since the bitops patch was merged > > Thanks for the reviews, Prafulla! > > MAINTAINERS | 4 + > MAKEALL | 1 + > Makefile | 3 + > board/Marvell/openrd_base/Makefile | 56 ++++++++ > board/Marvell/openrd_base/config.mk | 33 +++++ > board/Marvell/openrd_base/kwbimage.cfg | 168 > +++++++++++++++++++++++ > board/Marvell/openrd_base/openrd_base.c | 160 ++++++++++++++++++++++ > board/Marvell/openrd_base/openrd_base.h | 46 +++++++ > include/configs/openrd_base.h | 220 > +++++++++++++++++++++++++++++++ > 9 files changed, 691 insertions(+), 0 deletions(-) > create mode 100644 board/Marvell/openrd_base/Makefile > create mode 100644 board/Marvell/openrd_base/config.mk > create mode 100644 board/Marvell/openrd_base/kwbimage.cfg > create mode 100644 board/Marvell/openrd_base/openrd_base.c > create mode 100644 board/Marvell/openrd_base/openrd_base.h > create mode 100644 include/configs/openrd_base.h >
Applied to u-boot-marvell master branch Regards.. Prafulla . . _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
