From: Sandeep Paulraj <s-paul...@ti.com>
This patch enables EMAC on the DM365 EVM.
Signed-off-by: Sandeep Paulraj <s-paul...@ti.com>
---
board/davinci/dm365evm/dm365evm.c | 38 +++++++++++++++++++++++++++++++++++++
1 files changed, 38 insertions(+), 0 deletions(-)
diff --git a/board/davinci/dm365evm/dm365evm.c
b/board/davinci/dm365evm/dm365evm.c
index 99392b3..2092324 100644
--- a/board/davinci/dm365evm/dm365evm.c
+++ b/board/davinci/dm365evm/dm365evm.c
@@ -17,9 +17,11 @@
#include <common.h>
#include <nand.h>
+#include <asm/io.h>
#include <asm/arch/hardware.h>
#include <asm/arch/emif_defs.h>
#include <asm/arch/nand_defs.h>
+#include <netdev.h>
#include "../common/misc.h"
DECLARE_GLOBAL_DATA_PTR;
@@ -32,6 +34,42 @@ int board_init(void)
return 0;
}
+#ifdef CONFIG_DRIVER_TI_EMAC
+int board_eth_init(bd_t *bis)
+{
+ uint8_t eeprom_enetaddr[6];
+ int i;
+
+ /* Configure PINMUX 3 to enable EMAC pins */
+ writel((readl(PINMUX3) | 0x1affff), PINMUX3);
+
+ /* Configure GPIO20 as output */
+ writel((readl(GIO_DIR01) & 0xffefffff), GIO_DIR01);
+
+ /* Toggle GPIO 20 */
+ for (i = 0; i < 20; i++) {
+ /* GPIO 20 low */
+ writel((readl(GIO_OUT_DATA01) & 0xffefffff), GIO_OUT_DATA01);
+
+ udelay(1000);
+
+ /* GPIO 20 high */
+ writel((readl(GIO_OUT_DATA01) | 0x00100000), GIO_OUT_DATA01);
+ }
+
+ /* Configure I2C pins so that EEPROM can be read */
+ writel((readl(PINMUX3) | 0x01400000), PINMUX3);
+
+ /* Read Ethernet MAC address from EEPROM */
+ if (dvevm_read_mac_address(eeprom_enetaddr))
+ dv_configure_mac_address(eeprom_enetaddr);
+
+ davinci_emac_initialize();
+
+ return 0;
+}
+#endif
+
#ifdef CONFIG_NAND_DAVINCI
static void nand_dm365evm_select_chip(struct mtd_info *mtd, int chip)
{
--
1.6.0.4
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
