Hi Stephen, On 5 March 2016 at 23:26, Stephen Warren <swar...@wwwdotorg.org> wrote: > > On 02/05/2016 09:19 PM, Stephen Warren wrote: >> >> On 02/05/2016 02:43 PM, Eric Anholt wrote: >>> >>> For Raspberry Pi, we had the input clock rate to the pl011 fixed in >>> the rpi.c file, but it may be changed by firmware due to user changes >>> to config.txt. Since the firmware always sets up the uart (default >>> 115200 output unless the user changes it), we can just skip our own >>> uart init to simplify the boot process and more reliably get serial >>> output. >> >> >> Tested-by: Stephen Warren <swar...@wwwdotorg.org> >> (With a 6MHz init_uart_clock and with/without init_uart_baud=9600) > > > Simon/Tom, did this slip through the cracks, or are you deferring it until > the next release?
We haven't heard back on the review comments. I don't really mind if we go the DT approach or this one. But this patch needs a little rework I think. Regards, Simon _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
