On Fri, Feb 26, 2016 at 12:16 PM, Tom Rini <tr...@konsulko.com> wrote:
> On Thu, Feb 25, 2016 at 09:52:14AM -0600, Nishanth Menon wrote:
>
>> From: Vitaly Andrianov <vita...@ti.com>
>>
>> This commit replaces hard-coded EMIF and PHY DDR3 configurations for
>> predefined SODIMMs to a calculated configuration. The SODIMM parameters
>> are read from SODIMM's SPD and used to calculated the configuration.
>>
>> The current commit supports calculation for DDR3 with 1600MHz and 1333MHz
>> only.
>>
>> Signed-off-by: Vitaly Andrianov <vita...@ti.com>
>> Signed-off-by: Lokesh Vutla <lokeshvu...@ti.com>
>> Signed-off-by: Nishanth Menon <n...@ti.com>
> [snip]
>> +#ifdef DUMP_DDR_CONFIG
>> +static void dump_phy_config(struct ddr3_phy_config *ptr)
>
> Please figure out how to do this with debug() instead.
>
> [snip]
>> + puts("DDR3A Speed will be configured for 1333 Operation.\n");
>
> Just printf, always, it's fine, really.
>
Thank you for the review. Will try to do that and repost.
--
---
Regards,
Nishanth Menon
_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot
