Howdy, Currently on arm64 there is a big pile of mess when it comes to MMU support and page tables. Each board does its own little thing and the generic code is pretty dumb and nobody actually uses it.
This patch set tries to clean that up. After this series is applied, all boards except for the FSL Layerscape ones are converted to the new generic page table logic and have icache+dcache enabled. The new code always uses 4k page size. It dynamically allocates 1G or 2M pages for ranges that fit. When a dcache attribute request comes in that requires a smaller granularity than our previous allocation could fulfill, pages get automatically split. I have tested and verified the code works on HiKey (bare metal), vexpress64 (Foundation Model) and zynqmp (QEMU). The TX1 target is untested, but given the simplicity of the maps I doubt it'll break. ThunderX in theory should also work, but I haven't tested it. I would be very happy if people with access to those system could give the patch set a try. With this we're a big step closer to a good base line for EFI payload support, since we can now just require that all boards always have dcache enabled. I would also be incredibly happy if some Freescale people could look at their MMU code and try to unify it into the now cleaned up generic code. I don't think we're far off here. Alex v1 -> v2: - Fix comment for create_table() - Rework page table size calculation - Move mmu tables into board files - New patch: thunderx: Move mmu table into board file v2 -> v3: - Move PGTABLE_SIZE out of the ASSEMBLY section - Run pte splitting code in separate page table - Replace is_level in count_required_pts with more obvious pte_type - New patch: arm64: Disable TTBR1 maps in EL1 Alexander Graf (11): thunderx: Calculate TCR dynamically arm64: Disable TTBR1 maps in EL1 arm64: Make full va map code more dynamic thunderx: Move mmu table into board file zymqmp: Replace home grown mmu code with generic table approach tegra: Replace home grown mmu code with generic table approach vexpress64: Add MMU tables dwmmc: Increase retry timeout hikey: Add MMU tables arm64: Remove non-full-va map code arm64: Only allow dcache disabled in SPL builds arch/arm/cpu/armv8/cache.S | 54 +++ arch/arm/cpu/armv8/cache_v8.c | 546 +++++++++++++++++++------ arch/arm/cpu/armv8/fsl-layerscape/cpu.c | 37 +- arch/arm/cpu/armv8/zynqmp/cpu.c | 217 +++------- arch/arm/include/asm/arch-fsl-layerscape/cpu.h | 94 ++--- arch/arm/include/asm/armv8/mmu.h | 123 ++---- arch/arm/include/asm/global_data.h | 7 +- arch/arm/include/asm/system.h | 12 +- arch/arm/mach-tegra/arm64-mmu.c | 132 +----- board/armltd/vexpress64/vexpress64.c | 21 + board/cavium/thunderx/thunderx.c | 24 ++ board/hisilicon/hikey/hikey.c | 21 + doc/README.arm64 | 20 - drivers/mmc/dw_mmc.c | 2 +- include/configs/hikey.h | 4 +- include/configs/thunderx_88xx.h | 30 -- include/configs/vexpress_aemv8a.h | 5 +- 17 files changed, 733 insertions(+), 616 deletions(-) -- 1.8.5.6 _______________________________________________ U-Boot mailing list U-Boot@lists.denx.de http://lists.denx.de/mailman/listinfo/u-boot
