Wait for the link to come up on kirkwood network init

This patch makes the device wait for up to 5 seconds for the link to
come up, similar to what many of the other network drivers do. This
avoids confusing situations where, e.g., a tftp fails when initiated
early after U-boot has started (before the link has come up).

Signed-off-by: Simon Kagstrom <simon.kagst...@netinsight.net>
---
 drivers/net/kirkwood_egiga.c |   17 ++++++++++++-----
 1 files changed, 12 insertions(+), 5 deletions(-)

diff --git a/drivers/net/kirkwood_egiga.c b/drivers/net/kirkwood_egiga.c
index f31fefc..9ac9c1f 100644
--- a/drivers/net/kirkwood_egiga.c
+++ b/drivers/net/kirkwood_egiga.c
@@ -396,6 +396,7 @@ static int kwgbe_init(struct eth_device *dev)
 {
        struct kwgbe_device *dkwgbe = to_dkwgbe(dev);
        struct kwgbe_registers *regs = dkwgbe->regs;
+       int i;
 
        /* setup RX rings */
        kwgbe_init_rx_desc_ring(dkwgbe);
@@ -443,12 +444,18 @@ static int kwgbe_init(struct eth_device *dev)
 
 #if (defined (CONFIG_MII) || defined (CONFIG_CMD_MII)) \
         && defined (CONFIG_SYS_FAULT_ECHO_LINK_DOWN)
-       u16 phyadr;
-       miiphy_read(dev->name, 0xEE, 0xEE, &phyadr);
-       if (!miiphy_link(dev->name, phyadr)) {
-               printf("%s: No link on %s\n", __FUNCTION__, dev->name);
-               return -1;
+       /* Wait up to 5s for the link status */
+       for (i = 0; i < 5; i++) {
+               u16 phyadr;
+               miiphy_read(dev->name, 0xEE, 0xEE, &phyadr);
+               /* Return if we get link up */
+               if (miiphy_link(dev->name, phyadr))
+                       return 0;
+               udelay(1000000);
        }
+
+       printf("%s: No link on %s\n", __FUNCTION__, dev->name);
+       return -1;
 #endif
        return 0;
 }
-- 
1.6.0.4

_______________________________________________
U-Boot mailing list
U-Boot@lists.denx.de
http://lists.denx.de/mailman/listinfo/u-boot

Reply via email to